Chromium accumulation and ultrastructural changes in the mouse liver caused by stainless steel corrosion products

1995 ◽  
Vol 6 (9) ◽  
pp. 523-527 ◽  
Author(s):  
M. L. Pereira ◽  
A. M. Abreu ◽  
J. P. Sousa ◽  
G. S. Carvalho
Keyword(s):  
Stainless Steel ◽  
Mouse Liver ◽  
Steel Corrosion ◽  
Corrosion Products ◽  
Ultrastructural Changes ◽  
Chromium Accumulation

Leaching of Am-241 from a Radioactive Waste Glass Corroded in the Presence of Stainless Steel Corrosion Products and/or Bentonite

1987 ◽  
Vol 112 ◽  
Author(s):  
Masaki Tsukamoto ◽  
Inga-Kari Björner ◽  
Hilbert Christensen ◽  
Hans-Peter Hermansson ◽  
Lars Werme
Keyword(s):  
Stainless Steel ◽  
Radioactive Waste ◽  
Mass Loss ◽  
Total Mass ◽  
Corrosion Behaviour ◽  
Steel Corrosion ◽  
Waste Glass ◽  
Corrosion Products ◽  
Total Mass Loss ◽  
Elemental Mass

AbstractThe release of Am-241 during corrosion of the radioactive waste glass, JSS-A, has been studied in the presence of corrosion products and/or uncom-pacted bentonite. The corrosion behaviour of Am-241 has been analyzed using gamma spectrometry. Adsorption of Am-241 on bentonite is observed in all cases. The contents of Am-241 in centrifuged leachates are in most cases less than 1/100 of total values. The normalized elemental mass loss of Am increases initially with corrosion time, and the values in the presence of bentonite and corrosion products are larger than those in the presence of bentonite alone. This tendency is in agreement with results previously found for other elements. The release of Am is low, only about 10–20 % of the corresponding total mass loss.

Static Leaching of Fully Radioactive Waste Glass at 90°C in the Presence of Bentonite, Granite, and Stainless Steel Corrosion Products

1985 ◽  
Vol 50 ◽  
Author(s):  
Hans-Peter Hermansson ◽  
Inga-Kari Björner ◽  
Hilbert Christensen ◽  
Toshiaki Ohe ◽  
Lars Werme
Keyword(s):  
Stainless Steel ◽  
Radioactive Waste ◽  
Steel Corrosion ◽  
Corrosion Products ◽  
Leach Rate ◽  
Compacted Bentonite ◽  
Infrared Reflection ◽  
Leaching Experiments ◽  
Leaching Behaviour ◽  
Glass Leaching

AbstractThe results from the JSS phase II static glass leaching experiments are presented. The experiments have been performed in the presence of bentonite, granite and stainless steel corrosion products at 90°C for 28 days. The leaching behaviour of Cs has been analysed using gamma-spectrometry. The surface of the leached glass samples has been analysed by infrared reflection spectrometry.The presence of uncompacted bentonite seems to have a very small, increasing, effect on the leach rate of the glass compared to when no bentonite is present. In the presence of compacted bentonite, a lower leach rate has beep founy than in the prgsencelof uncompacted bentonite. (For Cs 0.3 g × m−2 × d−1 and 0.7 g × m−2 × d−1 respectively.) The addition of stainless steel corrosion products seems to have a slightly increasing effect on the leach rate in the presence of compacted bentonite. The beneficial effect of granite on the leach rate seems to be overshadowed by the presence of uncompacted bentonite.

Mouse inflammatory response to stainless steel corrosion products

1994 ◽  
Vol 5 (9-10) ◽  
pp. 596-600 ◽  
Author(s):  
R. B. Tracana ◽  
J. P. Sousa ◽  
G. S. Carvalho
Keyword(s):  
Stainless Steel ◽  
Inflammatory Response ◽  
Steel Corrosion ◽  
Corrosion Products

Stainless steel corrosion products cause alterations on mouse spleen cellular populations

1995 ◽  
Vol 6 (1) ◽  
pp. 56-61 ◽  
Author(s):  
R. B. Tracana ◽  
M. L. Pereira ◽  
A. M. Abreu ◽  
J. P. Sousa ◽  
G. S. Carvalho
Keyword(s):  
Stainless Steel ◽  
Steel Corrosion ◽  
Corrosion Products ◽  
Mouse Spleen

Protective postaction of inhibitor IFKhAN-92 for chromium-nickel stainless steel corrosion in hydrochloric acid

2019 ◽  
pp. 20-25
Author(s):  
Ya.G. Avdeev ◽  
◽  
Yu.B. Makarychev ◽  
D.S. Kuznetsov ◽  
L.P. Kazanskii ◽  
...  
Keyword(s):  
Stainless Steel ◽  
Hydrochloric Acid ◽  
Steel Corrosion

scholarly journals Experimental Analysis of Reinforcement Rust in Cement under Corrosive Environment

Coatings ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 241
Author(s):  
Xiaozhen Li ◽  
Hui Wang ◽  
Jianmin Wang ◽  
Junzhe Liu
Keyword(s):  
Photoelectron Spectroscopy ◽  
Steel Corrosion ◽  
Corrosion Products ◽  
Chloride Salt ◽  
Corrosive Environment ◽  
Cement Slurry ◽  
Passivation Film ◽  
Chloride Environment ◽  
Corrosive Environments ◽  
Structural Layer

In this work, the microstructure characteristics of corrosion products of reinforcement under a corrosive environment with chloride, carbonation and the combination of chloride-carbonization were studied by x-ray photoelectron spectroscopy (XPS) and scanning electron microscopy/energy spectroscopy (SEM-EDX). The results indicate that the outside of the passivation film reacts with the cement slurry to produce Fe–SiO4 in all three corrosive environments. The inner side is not completely corroded. The morphology of the corrosion is different in the three environments. In a chloride environment, corrosion products have obvious cracks, and the local layered structure is dense. In a carbonation environment, the surface of the steel corrosion shows a uniform granular structure and loose texture. With the combination of chloride and combination, the surface of the structural layer of steel corrosion was uneven and accompanied by protrusions, cracking and spalling occurred. The composition of the corrosion substances in the three corrosion environments are mainly composed of FeO, Fe3O4, Fe2O3 and Fe–SiO4. The content of iron oxide increases from a chloride salt, carbonization to the composite environment, indicating that the corrosion degree intensifies successively.

scholarly journals From Waste to Valuable Resource: Lignin as a Sustainable Anti-Corrosion Coating

Coatings ◽  
2018 ◽  
Vol 8 (12) ◽  
pp. 454 ◽  
Author(s):  
Arman Dastpak ◽  
Kirsi Yliniemi ◽  
Mariana de Oliveira Monteiro ◽  
Sarah Höhn ◽  
Sannakaisa Virtanen ◽  
...  
Keyword(s):  
Stainless Steel ◽  
Open Circuit Potential ◽  
Electrochemical Impedance ◽  
Steel Corrosion ◽  
Linear Sweep Voltammetry ◽  
Corrosion Current ◽  
Polymer Coatings ◽  
Open Circuit ◽  
Linear Sweep ◽  
Cyclic Potentiodynamic Polarization

In this study, a waste of biorefinery—lignin—is investigated as an anticorrosion coating on stainless steel. Corrosion behavior of two lignin types (hardwood beech and softwood spruce) was studied by electrochemical measurements (linear sweep voltammetry, open circuit potential, potentiostatic polarization, cyclic potentiodynamic polarization, and electrochemical impedance measurements) during exposure to simulated body fluid (SBF) or phosphate buffer (PBS). Results from linear sweep voltammetry of lignin-coated samples, in particular, demonstrated a reduction in corrosion current density between 1 and 3 orders of magnitude cf. blank stainless steel. Furthermore, results from cross cut adhesion tests on lignin-coated samples demonstrated that the best possible adhesion (grade 0) of ISO 2409 standard was achieved for the investigated novel coatings. Such findings suggest that lignin materials could transform the field of organic coatings towards more sustainable alternatives by replacing non-renewable polymer coatings.

Sign in / Sign up

Export Citation Format

Share Document