Zinc silicon phosphide (ZnSiP2) refractive index, dielectric constants

2005 ◽  
pp. 1-3
Author(s):  
Keyword(s):  
Refractive Index ◽  
Dielectric Constants ◽  
Zinc Silicon Phosphide

Infrared Intensities of Liquids XX: The Intensity of the OH Stretching Band of Liquid Water Revisited, and the Best Current Values of the Optical Constants of H2O(l) at 25°C between 15,000 and 1 cm−1

1996 ◽  
Vol 50 (8) ◽  
pp. 1047-1057 ◽  
Author(s):  
John E. Bertie ◽  
Zhida Lan
Keyword(s):  
Refractive Index ◽  
Liquid Water ◽  
Peak Height ◽  
Dielectric Constants ◽  
The Real ◽  
Infrared Intensities ◽  
Refractive Index Spectrum ◽  
Relative Errors ◽  
Integrated Intensities ◽  
Normal Laboratory

The previously reported nonreproducibility of the intensity of the OH stretching band of liquid water has been explored. It was found that it can be eliminated in measurements with the Circle® multiple ATR cell by ensuring that the ATR rod is coaxial with the glass liquid holder. It was also found that normal laboratory temperature variations of a few degrees change the intensity by ⩽∼1% of the peak height. A new imaginary refractive index spectrum of water has been determined between 4000 and 700 cm1 as the average of spectra calculated from ATR spectra recorded by four workers in our laboratory over the past seven years. It was obtained under experimental and computational conditions superior to those used previously, but is only marginally different from the spectra reported in 1989. In particular, the integrated intensities of the fundamentals are not changed significantly from those reported in 1989. The available imaginary refractive index, k, values between 15,000 and 1 cm−1 have been compared. The values that are judged to be the most reliable have been combined into a recommended k spectrum of H2O(l) at 25 °C between 15,000 and 1 cm−1, from which the real refractive index spectrum has been calculated by Kramers–Kronig transformation. The recommended values of the real and imaginary refractive indices and molar absorption coefficients of liquid water at 25 ± 1 °C are presented in graphs and tables. The real and imaginary dielectric constants and the real and imaginary molar polarizabilities in this wavenumber range can be calculated from the tables. Conservatively estimated probable errors of the recommended k values are given. The precision with which the values can be measured in one laboratory and the relative errors between regions are, of course, far smaller than these probable errors. The recommended k values should be of considerable value as interim standard intensities of liquid water, which will facilitate the transfer of intensities between laboratories.

scholarly journals Study and Simulation of a Sensor Based on 2D Photonic Crystals for the Detection of Aromatic Compounds: C6H5I, C6H5F and C6H5Cl

2021 ◽  
Vol 45 (4) ◽  
pp. 335-339
Author(s):  
Mehdi Ghoumazi ◽  
Messaoud Hameurlain
Keyword(s):  
Refractive Index ◽  
Energy Density ◽  
Photonic Crystals ◽  
Ring Resonator ◽  
Organic Materials ◽  
Simulation Software ◽  
Dielectric Constants ◽  
Total Energy Density ◽  
Materials Used ◽  
Comsol Simulation

A new study was presented on a new sensor based on two-dimensional photonic crystals (Phc's) to detect the following three organic materials: iodobenzene (C6H5I), fluorobenzene (C6H5F), chlorobenzene (C6H5Cl). These materials have dielectric constants (εr) equal to 2.623; 2.140; 2.318, respectively. The proposed sensor is a structure made of silicon rods submerged in air plus a ring resonator. The ring resonator is stuck between two horizontal waveguides. At the end of the ends of the structure there are four ports where port 1 and 2 belong to the top guide and port (3) and (4) the bottom one. In order to analyze the behavior of the sensor, a plane wave expansion approach (PWE) and the finite element method (FEM) are applied. Thanks to the MATLAB and COMSOL simulation software, we were able to obtain the following numerical results: the norm of the electric field, the total energy density and this last magnitude according to the refractive indices of the different organic materials used. We could observe variations in energy density for each material. So, this change is due to their refractive index which varies from one material to another. In this study, we have fixed the other parameters like the constant of the lattice "a" and the radius "r" and we are interested in the dielectric constants (εr) or more precisely the refractive index (n), the latter proves that it is one of the important parameters for detection.

CORONENE ORGANIC FILMS: OPTICAL AND SPECTRAL CHARACTERISTICS UNDER ANNEALING TEMPERATURE INFLUENCES

2021 ◽  
pp. 2150081
Author(s):  
ERMAN ERDOGAN
Keyword(s):  
Refractive Index ◽  
Annealing Temperature ◽  
Film Growth ◽  
Low Cost ◽  
Spectral Characteristics ◽  
Thin Film Deposition ◽  
Film Deposition ◽  
Optical Bandgap ◽  
Dielectric Constants ◽  
Optical Parameters

In this study, spin coating, which is a chemical film layer thin film deposition method, was used for coronene films that were grown on Si substrates annealed at 325, 350 and 375[Formula: see text]K to examine the impacts on the optical properties of films. This method allows for easy control of the deposition parameters such as concentration, temperature and time as well as enables the film growth at low cost. Optical (UV–Vis) spectral measurements in the wavelength range from 200[Formula: see text]nm to 800[Formula: see text]nm were used to extract the bandgap information and to calculate various optical parameters of the spin-coated coronene films. The electronic transitions on the absorption of photons of suitable energy are of indirect allowed type. The corresponding optical bandgap ([Formula: see text]) was determined. Complex dielectric constants, dissipation factor, optical and electrical conductances and refractive index of coronene films were analyzed as a function of temperature. As the film annealing temperature was increased, the dielectric constants and the refractive index values increased, whereas the optical bandgap and electrical and optical conductivity values decreased.

Investigate Dielectric Constants and Refractive Index of PMMA/SiO2 Nanocomposite and Protect from UV-Radiations

2019 ◽  
Vol 11 (1) ◽  
pp. 63-65
Author(s):  
Gyanesh Soni ◽  
Purushottam Soni ◽  
Deepika Rajawat ◽  
Swati Agrawal
Keyword(s):  
Refractive Index ◽  
Dielectric Constants

Stiff Polyimides: Chain Orientation And Anisotropy Of The Optical And Dielectric Properties Of Thin Films

1991 ◽  
Vol 227 ◽  
Author(s):  
D. Boese ◽  
S. Herminghaus ◽  
D. Y. Yoon ◽  
J. D. Swalen ◽  
J. F. Rabolt
Keyword(s):  
Thin Films ◽  
Dielectric Constant ◽  
Refractive Index ◽  
Dielectric Properties ◽  
Dielectric Constants ◽  
Polyimide Films ◽  
Lorenz Equation ◽  
Out Of Plane ◽  
Large Anisotropy ◽  
Uv Visible

ABSTRACTThin films of poly(p-phenylene biphenyltetracarboximide), prepared by thermal imidization of the precursor poly(amic acid) on substrates, have been investigated by optical waveguide, UV-visible, infrared (IR), and dielectric spectroscopies. The polyimide films exhibit an extraordinarily large anisotropy in the refractive indices with the in-plane index n║ = 1.852 and the out-of-plane index n┴ = 1.612 at 632.8 nm wavelength, indicating a strong preference of polymer chains to orient along the film plane. No discernible effect of the film thickness on this optical anisotropy is found in the range of ca. 0.4 μm to 7.8 μm in thickness. The frequency dispersion of the in-plane refractive index to 1.06 μm wavelength is consistent with the results calculated by the Lorentz-Lorenz equation from the UV-visible spectrum. The contribution from the entire IR range from 7000 to 200 cm,−1 computed by the Spitzer-Kleinmann dispersion relations from the measured spectra, adds ca. 0.07 to the in-plane refractive index n║. Approximately the same increase is assumed for the out-of-plane index n┴, based on the tilt-angle dependent IR results. Application of the Maxwell relation leads to the out-of-plane dielectric constant ε┴≃2.8 at ca. 1013 Hz, as compared with the measured value of ca. 3.0 at 106 Hz. Assuming this small difference to remain the same for the in-plane dielectric constants ε║, we obtain a a very large anisotropy in the dielectric properties of these polyimide films with the estimated in-plane dielectric constant ε║≃3.5 at ca. 1013 Hz, and ε.≃3.7 at 106 Hz.

scholarly journals Dielectric Constant, Metallization Criterion and Optical Properties of CuO Doped TeO2-B2O3 Glasses

2021 ◽  
Author(s):  
NAZIRUL NAZRIN SHAHROL NIDZAM ◽  
S.A. Umar ◽  
M.K. Halimah ◽  
M.M. Marian ◽  
Z.W. Najwa ◽  
...  
Keyword(s):  
Dielectric Constant ◽  
Refractive Index ◽  
Molar Volume ◽  
Copper Ion ◽  
Volume Density ◽  
Dielectric Constants ◽  
Physical Parameters ◽  
Laser Applications ◽  
Optical Dielectric Constant ◽  
Ftir Spectral Analysis

Abstract Copper oxide doped TeO2 – B2O3 glass system with empirical formula; [(B2O3)0.3(TeO2)0.7]1-x(CuO)x using the melt quenching method, where x = 0.0, 0.01, 0.015, 0.02, and 0.025 was combined. The glass samples’ density and molar volume were measured, followed by characterizations using the UV-Vis, Fourier transform infrared (FTIR) and X-ray diffraction (XRD) spectroscopes. The amorphous or glassy nature of glass samples was proven by the XRD spectra except for the pure borotellurite sample which showed a peak around 2θ = 20o, indicating α-TeO2 crystalline phase presence. The FTIR spectral analysis suggested the presence of BO3, TeO3 and TeO4 as the structural functional units in the glass samples. The UV-Vis spectra showed no presence of any sharply defined edges, affirming the amorphous or glassy nature of the glass materials. Physical parameters e.g. molar volume, density, oxygen packing density (OPD), inter ionic distance of Cu2+ ions, concentration of copper ion per unit volume (N), as well as the polaron radius data were presented and discussed. Also, the direct bandgap (3.8900 to 3.5900 eV) , indirect bandgap (3.3200 to 3.0800 eV), refractive index (2.318 to 2.378), dielectric constant (5.3731 to 5.6549), optical dielectric constant (4.3731 to 4.6549), refractive index based metallization criterion (0.406885 to 0.391916) and the band gap based metallization criterion (0.407431 to 0.392428) were analysed and discussed. Based on the metallization criterion and values of refractive index, the glasses are good candidates for optoelectronic and laser applications. Meanwhile, the dielectric constants’ values of the present glasses indicate their suitability bandpass filters and microelectronic substrates applications.

Sign in / Sign up

Export Citation Format

Share Document