Numerical simulation of wind tunnel wall effects on wind turbine flows

Wind Energy ◽  
10.1002/we.35 ◽  
2000 ◽  
Vol 3 (3) ◽  
pp. 135-148 ◽  
Author(s):  
Tongguang Wang ◽  
Frank N. Coton
Keyword(s):  
Numerical Simulation ◽  
Wind Tunnel ◽  
Wind Turbine ◽  
Wall Effects ◽  
Tunnel Wall

Development and Validation of a CFD Technique for the Aerodynamic Analysis of HAWT

2009 ◽  
Vol 131 (3) ◽  
Author(s):  
S. Gómez-Iradi ◽  
R. Steijl ◽  
G. N. Barakos
Keyword(s):  
Wind Tunnel ◽  
Wind Turbine ◽  
Wind Turbines ◽  
Turbine Blades ◽  
Wind Tunnel Test ◽  
Unsteady Aerodynamics ◽  
Tunnel Wall ◽  
Local Flow ◽  
Flow Angle ◽  
Thrust And Torque

This paper demonstrates the potential of a compressible Navier–Stokes CFD method for the analysis of horizontal axis wind turbines. The method was first validated against experimental data of the NREL/NASA-Ames Phase VI (Hand, et al., 2001, “Unsteady Aerodynamics Experiment Phase, VI: Wind Tunnel Test Configurations and Available Data Campaigns,” NREL, Technical Report No. TP-500-29955) wind-tunnel campaign at 7 m/s, 10 m/s, and 20 m/s freestreams for a nonyawed isolated rotor. Comparisons are shown for the surface pressure distributions at several stations along the blades as well as for the integrated thrust and torque values. In addition, a comparison between measurements and CFD results is shown for the local flow angle at several stations ahead of the wind turbine blades. For attached and moderately stalled flow conditions the thrust and torque predictions are fair, though improvements in the stalled flow regime are necessary to avoid overprediction of torque. Subsequently, the wind-tunnel wall effects on the blade aerodynamics, as well as the blade/tower interaction, were investigated. The selected case corresponded to 7 m/s up-wind wind turbine at 0 deg of yaw angle and a rotational speed of 72 rpm. The obtained results suggest that the present method can cope well with the flows encountered around wind turbines providing useful results for their aerodynamic performance and revealing flow details near and off the blades and tower.

Wind-tunnel wall effects on delta wings

1989 ◽  
Vol 26 (5) ◽  
pp. 403-404 ◽  
Author(s):  
Neal T. Frink
Keyword(s):  
Wind Tunnel ◽  
Wall Effects ◽  
Tunnel Wall ◽  
Delta Wings

scholarly journals Numerical Simulation and Wind Tunnel Investigation on Static Characteristics of VAWT Rotor Starter with Lift-Drag Combined Structure

Energies ◽  
2021 ◽  
Vol 14 (19) ◽  
pp. 6167
Author(s):  
Fang Feng ◽  
Guoqiang Tong ◽  
Yunfei Ma ◽  
Yan Li
Keyword(s):  
Numerical Simulation ◽  
Wind Speed ◽  
Wind Tunnel ◽  
Wind Turbine ◽  
Wind Turbines ◽  
Speed Ratio ◽  
Static Characteristics ◽  
Torque Coefficient ◽  
Starting Characteristics ◽  
Static Torque

In order to get rid of the impact of the global financial crisis and actively respond to global climate change, it has become a common choice for global economic development to develop clean energy such as wind energy, improve energy efficiency and reduce greenhouse gas emissions. With the advantages of simple structure, unnecessary facing the wind direction, and unique appearance, the vertical axis wind turbine (VAWT) attracts extensive attention in the field of small and medium wind turbines. The lift-type VAWT exhibits outstanding aerodynamic characteristics at a high tip speed ratio, while the starting characteristics are generally undesirable at a low wind speed; thus, how to improve the starting characteristics of the lift-type VAWT has always been an important issue. In this paper, a lift-drag combined starter (LDCS) suitable for lift-type VAWT was proposed to optimize the starting characteristics of lift-type VAWT. With semi-elliptical drag blades and lift blades equipped on the middle and rear part outside the starter, the structure is characterized by lift-drag combination, weakening the adverse effect of the starter with semi-elliptical drag blades alone on the output performance of the original lift-type VAWT and improving the characteristics of the lift-drag combined VAWT. The static characteristic is one of the important starting characteristics of the wind turbine. The rapid development of computational fluid dynamics has laid a solid material foundation for VAWT. Thus the static characteristics of the LDCS with different numbers of blades were investigated by conducting numerical simulation and wind tunnel tests. The results demonstrated that the static torque coefficient of LDCS increased significantly with the increased incoming wind speed. The average value of the static torque coefficient also increased significantly. This study can provide guidelines for the research of lift-drag combined wind turbines.

Sign in / Sign up

Export Citation Format

Share Document