scholarly journals PIV measurements and CFD simulation of the performance and flow physics and of a small-scale vertical axis wind turbine

Wind Energy ◽  
2013 ◽  
Vol 18 (2) ◽  
pp. 201-217 ◽  
Author(s):  
Jonathan M. Edwards ◽  
Louis Angelo Danao ◽  
Robert J. Howell
Keyword(s):  
Wind Turbine ◽  
Cfd Simulation ◽  
Vertical Axis ◽  
Small Scale ◽  
Vertical Axis Wind Turbine ◽  
Piv Measurements ◽  
Flow Physics

Numerical and Experimental Study on Performance Enhancement of Darrieus Vertical Axis Wind Turbine With Wingtip Devices

2018 ◽  
Vol 140 (12) ◽  
Author(s):  
Nishant Mishra ◽  
Anand Sagar Gupta ◽  
Jishnav Dawar ◽  
Alok Kumar ◽  
Santanu Mitra
Keyword(s):  
Wind Turbine ◽  
Cfd Simulation ◽  
Performance Enhancement ◽  
Vertical Axis ◽  
Small Scale ◽  
Vertical Axis Wind Turbine ◽  
Sliding Mesh ◽  
Wind Speeds ◽  
Computational Fluid Dynamics Cfd ◽  
Working Parameters

Darrieus type vertical axis wind turbines (VAWT) are being used commercially nowadays; however, they still need to improve in terms of performance as they work in an urban environment where the wind speeds are low and the gusts are frequent. The aerodynamic performance of Darrieus turbine is highly affected by the wingtip vortices. This paper attempts at analyzing and comparing the performance of Darrieus with the use of various wingtip devices. Attempts have also been made to find out optimal working parameters by studying the flow through turbines with different tip speed ratios and different inlet wind speeds. A comparative computational fluid dynamics (CFD) simulation was performed on a small-scale, straight-bladed Darrieus rotor vertical axis wind turbine, with a large stationary domain and a small rotating subdomain using sliding mesh technique. Comparison of the performance of end tip device that can be used against a baseline rotor configuration is done, with the aim of identifying the best tip architecture. The main focus lies on building an experimental setup to validate the results obtained with the CFD simulation and to compare the performance with and without wingtip device. VAWTs with wingtip device show very promising results compared to the baseline model.

Aerodynamic and aeroacoustic performance investigations on modified H-rotor Darrieus wind turbine

2021 ◽  
pp. 0309524X2110039
Author(s):  
Amgad Dessoky ◽  
Thorsten Lutz ◽  
Ewald Krämer
Keyword(s):  
Wind Turbine ◽  
High Speed ◽  
Cfd Simulation ◽  
Vertical Axis ◽  
3D Models ◽  
Power Coefficient ◽  
Design Parameters ◽  
Second Phase ◽  
Vertical Axis Wind Turbine ◽  
Guide Vanes

The present paper investigates the aerodynamic and aeroacoustic characteristics of the H-rotor Darrieus vertical axis wind turbine (VAWT) combined with very promising energy conversion and steering technology; a fixed guide-vanes. The main scope of the current work is to enhance the aerodynamic performance and assess the noise production accomplished with such enhancement. The studies are carried out in two phases; the first phase is a parametric 2D CFD simulation employing the unsteady Reynolds-averaged Navier-Stokes (URANS) approach to optimize the design parameters of the guide-vanes. The second phase is a 3D CFD simulation of the full turbine using a higher-order numerical scheme and a hybrid RANS/LES (DDES) method. The guide-vanes show a superior power augmentation, about 42% increase in the power coefficient at λ = 2.75, with a slightly noisy operation and completely change the signal directivity. A remarkable difference in power coefficient is observed between 2D and 3D models at the high-speed ratios stems from the 3D effect. As a result, a 3D simulation of the capped Darrieus turbine is carried out, and then a noise assessment of such configuration is assessed. The results show a 20% increase in power coefficient by using the cap, without significant change in the noise signal.

Computational fluid dynamic analysis of roof-mounted vertical-axis wind turbine with diffuser shroud, flange, and vanes

2018 ◽  
Vol 42 (4) ◽  
pp. 404-415
Author(s):  
H. Abu-Thuraia ◽  
C. Aygun ◽  
M. Paraschivoiu ◽  
M.A. Allard
Keyword(s):  
Wind Turbine ◽  
Urban Areas ◽  
Guide Vane ◽  
Fluid Dynamic ◽  
Vertical Axis ◽  
Power Coefficient ◽  
Small Scale ◽  
Vertical Axis Wind Turbine ◽  
Guide Vanes ◽  
Turbine Design

Advances in wind power and tidal power have matured considerably to offer clean and sustainable energy alternatives. Nevertheless, distributed small-scale energy production from wind in urban areas has been disappointing because of very low efficiencies of the turbines. A novel wind turbine design — a seven-bladed Savonius vertical-axis wind turbine (VAWT) that is horizontally oriented inside a diffuser shroud and mounted on top of a building — has been shown to overcome the drawback of low efficiency. The objective this study was to analyze the performance of this novel wind turbine design for different wind directions and for different guide vanes placed at the entrance of the diffuser shroud. The flow field over the turbine and guide vanes was analyzed using computational fluid dynamics (CFD) on a 3D grid for multiple tip-speed ratios (TSRs). Four wind directions and three guide-vane angles were analyzed. The wind-direction analysis indicates that the power coefficient decreases to about half when the wind is oriented at 45° to the main axis of the turbine. The analysis of the guide vanes indicates a maximum power coefficient of 0.33 at a vane angle of 55°.

Sign in / Sign up

Export Citation Format

Share Document