High-density and energy saving technologies for electric power converters

2009 ◽  
Vol 4 (1) ◽  
pp. 44-45
Author(s):  
Takaharu Takeshita
Keyword(s):  
Energy Saving ◽  
Electric Power ◽  
Power Converters ◽  
High Density

scholarly journals Energy-Saving and CO2-Emissions-Reduction Potential of a Fuel Cell Cogeneration System for Condominiums Based on a Field Survey

Energies ◽  
2021 ◽  
Vol 14 (20) ◽  
pp. 6611
Author(s):  
Kazui Yoshida ◽  
Hom B. Rijal ◽  
Kazuaki Bohgaki ◽  
Ayako Mikami ◽  
Hiroto Abe
Keyword(s):  
Power Generation ◽  
Energy Consumption ◽  
Fuel Cell ◽  
Energy Saving ◽  
Electric Power ◽  
Water Use ◽  
Co2 Emission ◽  
Contribution Rate ◽  
Electric Power Generation ◽  
Cogeneration System

A residential cogeneration system (CGS) is highlighted because of its efficient energy usage on both the supplier and consumer sides. It generates electricity and heat simultaneously; however, there is insufficient information on the efficiency according to the condition of usage. In this study, we analysed the performance data measured by the home energy management system (HEMS) and the lifestyle data of residents in a condominium of 356 flats where fuel cell CGS was installed in each flat. The electricity generated by CGS contributed to an approximately 12% reduction in primary energy consumption and CO2 emission, and the rate of generation by the CGS in the electric power demand (i.e., contribution rate) was approximately 38%. The electricity generation was mainly affected by the use of electricity up to 4 MWh/household/year. Gas or water use also impacted electric power generation, with water use as the primary factor affecting the contribution rate. Electric power generation changes monthly, mainly based on the water temperature. From these results, we confirmed that a CGS has substantial potential to reduce energy consumption and CO2 emission in condominiums. Thus, it is recommended for installation of fuel cell CGS in existing and new buildings to contribute to the energy-saving target of the Japanese Government in the residential sector.

Stress Reduction

2016 ◽  
pp. 262-301
Keyword(s):  
Electric Power ◽  
Design Process ◽  
Stress Reduction ◽  
Printed Circuit Board ◽  
Power Converters ◽  
High Amplitude ◽  
Power Converter ◽  
Operating Conditions ◽  
Circuit Board ◽  
Inrush Current

After evaluation of reliability in the previous chapters and its consideration as a converter figure of merit, in this and the next chapters, guidelines for improvement of reliability are presented. These methods are used in both design and operation process of the converter. The focus of this chapter is on the component stress reduction in the design process. Based on background of chapter two, reliability of a converter increases if it operates at a set point with low stress. It is assumed that the converter is under design process or operates without fault. The methods for reliability improvement in faulty converters are discussed in the next chapters. In this chapter, methods for reducing electric field are described at both system and printed circuit board level. Low temperature operating conditions for an electric power converter are described and tools for this goal are presented. Series connection for voltage sharing and parallel connection for current sharing is explained. Novel control methods of power converters for reducing the complexity and reliable operation are presented. Control of inrush current as a typical transient problem in electric power converters is presented. Methods for preventing the over stress condition on the components in faulty cases are described. Techniques for reducing mechanical and environmental stress are expressed. Mechanical dampers for preventing the high amplitude vibration and insulating colors against humidity are presented. Industrial and real samples are presented to demonstrate application of the proposed methods.

Sign in / Sign up

Export Citation Format

Share Document