Model studies of slag carry-over during drainage of metallurgical vessels

1994 ◽  
Vol 65 (1) ◽  
pp. 8-14 ◽  
Author(s):  
Satish C. Koria ◽  
Uma Kanth
Keyword(s):  
Model Studies ◽  
Carry Over ◽  
Slag Carry Over

Investigation on the control of multiphase flow behavior in a continuous casting tundish during ladle change

2020 ◽  
Vol 117 (6) ◽  
pp. 619
Author(s):  
Rui Xu ◽  
Haitao Ling ◽  
Haijun Wang ◽  
Lizhong Chang ◽  
Shengtao Qiu
Keyword(s):  
Multiphase Flow ◽  
Flow Behavior ◽  
Rolled Strip ◽  
Impact Zone ◽  
Steel Cleanliness ◽  
Carry Over ◽  
Slag Carry Over ◽  
Hot Rolled ◽  
Turbulence Inhibitor ◽  
The Impact

The transient multiphase flow behavior in a single-strand tundish during ladle change was studied using physical modeling. The water and silicon oil were employed to simulate the liquid steel and slag. The effect of the turbulence inhibitor on the slag entrainment and the steel exposure during ladle change were evaluated and discussed. The effect of the slag carry-over on the water-oil-air flow was also analyzed. For the original tundish, the top oil phase in the impact zone was continuously dragged into the tundish bath and opened during ladle change, forming an emulsification phenomenon. By decreasing the liquid velocities in the upper part of the impact zone, the turbulence inhibitor decreased considerably the amount of entrained slag and the steel exposure during ladle change, thereby eliminating the emulsification phenomenon. Furthermore, the use of the TI-2 effectively lowered the effect of the slag carry-over on the steel cleanliness by controlling the movement of slag droplets. The results from industrial trials indicated that the application of the TI-2 reduced considerably the number of linear inclusions caused by ladle change in hot-rolled strip coils.

SA-ANN-Based Slag Carry-Over Detection Method and the Embedded WME Platform

2013 ◽  
Vol 60 (10) ◽  
pp. 4702-4713 ◽  
Author(s):  
Da-Peng Tan ◽  
Pei-Yu Li ◽  
Yi-Xuan Ji ◽  
Dong-Hui Wen ◽  
Chen Li
Keyword(s):  
Detection Method ◽  
Carry Over ◽  
Slag Carry Over

scholarly journals Numerical Analysis of Slag Carry-Over during Molten Steel Draining

2017 ◽  
Vol 07 (11) ◽  
pp. 611-616
Author(s):  
Daniel Flores-Sanchez ◽  
Miguel A. Barron
Keyword(s):  
Numerical Analysis ◽  
Molten Steel ◽  
Carry Over ◽  
Slag Carry Over

scholarly journals New Process with Argon Injected into Ladle around the Tapping Hole for Controlling Slag Carry-over during Continuous Casting Ladle

Metals ◽  
2018 ◽  
Vol 8 (8) ◽  
pp. 624 ◽  
Author(s):  
Shuguo Zheng ◽  
Miaoyong Zhu
Keyword(s):  
Angular Velocity ◽  
Continuous Casting ◽  
Physical Modeling ◽  
Critical Height ◽  
Casting Ladle ◽  
New Process ◽  
Carry Over ◽  
Plant Trials ◽  
Slag Carry Over

A new process with argon injected into the ladle around the tapping hole for controlling slag carry-over in a teeming ladle was presented. Physical modeling was used to study the mechanism of controlling slag carry-over, and the feasibility of the new process was also investigated by industrial trials. The results show that vortex forms firstly, and then converts to drain sink. With argon injected into the ladle around the tapping hole, an argon ring was formed, and the rotating angular velocity of the melt close to the tapping hole reduced dramatically, and even vanished when the melt passed the argon ring. Therefore, the new controlling slag carry-over process can eliminate the slag carry-over caused by vortex. The velocity of the melt toward the tapping hole was reduced due to the bubble buoyancy as the melt passed the argon ring. So, the new process can decrease the critical height of slag carry-over caused by drain sink. The application feasibility of the new controlling slag carry-over process is verified by the plant trials. Compared to the traditional teeming ladle process, the new controlling slag carry-over process shows much better efficiency on decreasing the steel residual in the poured ladle.

Minimizing Carry-Over Effects After Treatment Failure and Maximizing Therapeutic Outcome

2014 ◽  
Vol 222 (3) ◽  
pp. 171-178 ◽  
Author(s):  
Mareile Hofmann ◽  
Nathalie Wrobel ◽  
Simon Kessner ◽  
Ulrike Bingel
Keyword(s):  
Treatment Failure ◽  
Human Subjects ◽  
Subsequent Treatment ◽  
Clinical Samples ◽  
Administration Route ◽  
Healthy Human ◽  
Negative Experiences ◽  
Analgesic Treatment ◽  
Balanced Design ◽  
Carry Over

According to experimental and clinical evidence, the experiences of previous treatments are carried over to different therapeutic approaches and impair the outcome of subsequent treatments. In this behavioral pilot study we used a change in administration route to investigate whether the effect of prior treatment experience on a subsequent treatment depends on the similarity of both treatments. We experimentally induced positive or negative experiences with a topical analgesic treatment in two groups of healthy human subjects. Subsequently, we compared responses to a second, unrelated and systemic analgesic treatment between both the positive and negative group. We found that there was no difference in the analgesic response to the second treatment between the two groups. Our data indicate that a change in administration route might reduce the influence of treatment history and therefore be a way to reduce negative carry-over effects after treatment failure. Future studies will have to validate these findings in a fully balanced design including larger, clinical samples.

Does CBT for Psychosis Have an Impact on Delusions by Improving Reasoning Biases and Negative Self-Schemas?

2018 ◽  
Vol 226 (3) ◽  
pp. 152-163 ◽  
Author(s):  
Stephanie Mehl ◽  
Björn Schlier ◽  
Tania M. Lincoln
Keyword(s):  
Behavioral Therapy ◽  
Theoretical Models ◽  
Self Esteem ◽  
Secondary Outcome ◽  
Intervention Effect ◽  
Produce Change ◽  
Attribution Biases ◽  
Carry Over ◽  
Implicit And Explicit ◽  
Reasoning Biases

Abstract. Cognitive-behavioral therapy for psychosis (CBTp) builds on theoretical models that postulate reasoning biases and negative self-schemas to be involved in the formation and maintenance of delusions. However, it is unclear whether CBTp induces change in delusions by improving these proposed causal mechanisms. This study reports on a mediation analysis of a CBTp effectiveness trial in which delusions were a secondary outcome. Patients with psychosis were randomized to individualized CBTp (n = 36) or a waiting list condition (WL; n = 34). Reasoning biases (jumping to conclusions, theory of mind, attribution biases) and self-schemas (implicit and explicit self-esteem; self-schemas related to different domains) were assessed pre- and post-therapy/WL. The results reveal an intervention effect on two of four measures of delusions and on implicit self-esteem. Nevertheless, the intervention effect on delusions was not mediated by implicit self-esteem. Changes in explicit self-schemas and reasoning biases did also not mediate the intervention effects on delusions. More focused interventions may be required to produce change in reasoning and self-schemas that have the potential to carry over to delusions.

Sign in / Sign up

Export Citation Format

Share Document