Incorporation of Anatase TiO 2 to Highly Porous Silica (BMMs) for Photo‐Degradation of Alizarin Red Dye in Aqueous Solution

2021 ◽  
Vol 6 (26) ◽  
pp. 6816-6825
Author(s):  
Anadil Gul ◽  
Jihong Sun ◽  
Raza Ullah ◽  
Tallat Munir ◽  
Shiyang Bai
2019 ◽  
Author(s):  
Chem Int

The high energy radiation overcome the bonding of solute in a solution and H2O2 acts as an oxidizing agent and generates a free radical in the solution which results in photo-degradation by converting the solute in to simple form and resultantly, colored substance under the effect of photo-degradation becomes colorless. The photo-degradation of monoazo dye Blue 13 in an aqueous solution was investigated using a laboratory scale UV lamp in the presence of H2O2 and for maximum degradation of dye, the independent parameter UV power, UV exposure time, pH and H2O2 concentration were optimized. It was found that neither UV in the presence of H2O2 is able to degrade Blue 13 under optimum condition. The results revealed that the use of both UV and H2O2 have pronounced effect on the discoloration of dyes which could be used for management of textile effluents contain waste dyes.


2021 ◽  
Vol 765 (1) ◽  
pp. 012089
Author(s):  
R Taufik ◽  
M Mohamad ◽  
R Wannahari ◽  
N F Shoparwe ◽  
WHW Osman ◽  
...  

2000 ◽  
Vol 612 ◽  
Author(s):  
Sylvie Acosta ◽  
André Ayral ◽  
Christian Guizard ◽  
Charles Lecornec ◽  
Gérard Passemard ◽  
...  

AbstractPorous silica exhibits attractive dielectric properties, which make it a potential candidate for use as insulator into interconnect structures. A new way of preparation of highly porous silica layers by the sol-gel route was investigated and is presented. The synthesis strategy was based on the use of common and low toxicity reagents and on the development of a simple process without gaseous ammonia post-treatment or supercritical drying step. Defect free layers were deposited by spin coating on 200 mm silicon wafers and characterized. Thin layers with a total porosity larger than 70% and an average pore size of 5 nm were produced. The dielectric constant measured under nitrogen flow on these highly porous layers is equal to ∼ 2.5, which can be compared to the value calculated from the measured porosity, ∼ 1.9. This difference is explained by the presence of water adsorbed on the hydrophilic surface of the unmodified silica.


2013 ◽  
Vol 51 (28-30) ◽  
pp. 5638-5648 ◽  
Author(s):  
Muhammad Imran Din ◽  
Zaib Hussain ◽  
Muhammad Latif Mirza ◽  
Muhammad Makshoof Athar ◽  
Asadullah Madni ◽  
...  

2019 ◽  
Vol 70 (10) ◽  
pp. 3473-3476 ◽  
Author(s):  
Laura Cocheci ◽  
Lavinia Lupa ◽  
Aniela Pop ◽  
Aurelia Visa ◽  
Bianca Maranescu ◽  
...  

In the present study, a new compound was used for decontaminating water polluted by Congo Red dye. Phosphono-aminoacid-Cd(II) pendant groups grafted on a polymeric support was prepared using impregnation of a polymer support functionalized with phosphono-aminoacid groups with an aqueous solution of Cd(NO3)2x4H2O. The catalyst was characterized by Fourier transform infrared ray, scanning electron microscope, termogravimetric analysis UV-Vis spectroscopy. The results suggest that the studied material could efficiently be used as photocatalyst in the degradation process of waters containing organic dyes under UV-Vis light irradiation.


2015 ◽  
Vol 11 (9) ◽  
pp. 3950-3958 ◽  
Author(s):  
Chandrakant Vedu Nandre ◽  
C.P. Sawant

In the present study photocatalytic degradation of hazardous water soluble alizarin red dye by using Fe-Co nanoparticles  has been investigated. Fe-Co nanoparticles was synthesized by chemical co-precipitation method and characterized by TEM, SEM, EDAX and XRD. The photocatalytic degradation have been studied with the help of variety of parameters such as catalytic dose, dye concentration, pH, contact time and most important chemical oxygen demand. It was observed that The photocatalytic degradation of alizarin red dye by using Fe-Co nanoparticles was an effective ,economic, ecofriendly and faster mode of removing dye from an aqueous solution. The optimum condition for the degradation of the dye was 50 mg/L,pH 8.0, catalyst dose 60 mg/L and contact time 60 minutes. The kinetic studies also have been studied.


Sign in / Sign up

Export Citation Format

Share Document