A new approach to training back-propagation artificial neural networks: empirical evaluation on ten data sets from clinical studies

2002 ◽  
Vol 21 (9) ◽  
pp. 1309-1330 ◽  
Author(s):  
Antonio Ciampi ◽  
Fulin Zhang
Keyword(s):  
Neural Networks ◽  
Artificial Neural Networks ◽  
Clinical Studies ◽  
Empirical Evaluation ◽  
Back Propagation ◽  
Data Sets ◽  
New Approach ◽  
Artificial Neural

scholarly journals Prediction of adsorption efficiencies of Ni (II) in aqueous solutions with perlite via artificial neural networks

2017 ◽  
Vol 43 (4) ◽  
pp. 26-32 ◽  
Author(s):  
Sinan Mehmet Turp
Keyword(s):  
Neural Network ◽  
Experimental Data ◽  
Neural Networks ◽  
Artificial Neural Network ◽  
Artificial Neural Networks ◽  
Back Propagation ◽  
Data Sets ◽  
Adsorption Efficiency ◽  
Back Propagation Algorithm ◽  
Artificial Neural

AbstractThis study investigates the estimated adsorption efficiency of artificial Nickel (II) ions with perlite in an aqueous solution using artificial neural networks, based on 140 experimental data sets. Prediction using artificial neural networks is performed by enhancing the adsorption efficiency with the use of Nickel (II) ions, with the initial concentrations ranging from 0.1 mg/L to 10 mg/L, the adsorbent dosage ranging from 0.1 mg to 2 mg, and the varying time of effect ranging from 5 to 30 mins. This study presents an artificial neural network that predicts the adsorption efficiency of Nickel (II) ions with perlite. The best algorithm is determined as a quasi-Newton back-propagation algorithm. The performance of the artificial neural network is determined by coefficient determination (R2), and its architecture is 3-12-1. The prediction shows that there is an outstanding relationship between the experimental data and the predicted values.

scholarly journals Advanced approach to numerical forecasting using artificial neural networks

2009 ◽  
Vol 57 (6) ◽  
pp. 297-304 ◽  
Author(s):  
Michael Štencl ◽  
Jiří Šťastný
Keyword(s):  
Neural Networks ◽  
Artificial Neural Networks ◽  
Learning Algorithm ◽  
Information Age ◽  
Back Propagation ◽  
Global Market ◽  
Data Sets ◽  
Incoming Information ◽  
Past Data ◽  
Artificial Neural

Current global market is driven by many factors, such as the information age, the time and amount of information distributed by many data channels it is practically impossible analyze all kinds of incoming information flows and transform them to data with classical methods. New requirements could be met by using other methods. Once trained on patterns artificial neural networks can be used for forecasting and they are able to work with extremely big data sets in reasonable time. The patterns used for learning process are samples of past data. This paper uses Radial Basis Functions neural network in comparison with Multi Layer Perceptron network with Back-propagation learning algorithm on prediction task. The task works with simplified numerical time series and includes forty observations with prediction for next five observations. The main topic of the article is the identification of the main differences between used neural networks architectures together with numerical forecasting. Detected differences then verify on practical comparative example.

ARTIFICIAL NEURAL NETWORKS IN THE IDENTIFICATION OF PERIPHERAL NERVE DISORDERS

2012 ◽  
Vol 12 (04) ◽  
pp. 1240018 ◽  
Author(s):  
REEDA KUNHIMANGALAM ◽  
SUJITH OVALLATH ◽  
PAUL K. JOSEPH
Keyword(s):  
Neural Networks ◽  
Artificial Neural Networks ◽  
Peripheral Nerve ◽  
Confusion Matrix ◽  
Back Propagation ◽  
Data Sets ◽  
Training Algorithms ◽  
Feed Forward Neural Network ◽  
Medical College ◽  
Artificial Neural

The recent years have witnessed an increase in the use of newer analytical tools in the field of medicine to assist in diagnostic procedure. Among the new tools, artificial neural networks (ANNs) have received particular attention because of their ability to analyze complex nonlinear data sets. This study suggests that ANNs can be used for the diagnosis of peripheral nerve disorders particularly the carpal tunnel syndrome (CTS) and neuropathy. This paper aims at building a classifier using a feed forward neural network that can distinguish between CTS, neuropathy, and normal controls using a reduced set of measurements or features from nerve conduction study (NCS) data. Three different ANN training algorithms, viz. Levenberg–Marquardt (LM), Conjugate gradient (CGB), and resilient back-propagation (RP) are used to see which algorithm produces better results and has faster training for the application under consideration. The data used were obtained from the Neurology Department, Kannur Medical College, Kerala, India. The obtained resultant confusion matrix indicated only a few misclassifications in all the three cases. The analysis showed that the CGB and RB algorithms provide faster convergence on pattern recognition problems, but the best performance in terms of accuracy is given by the LM algorithm. The accuracy obtained for the LM, CGB, and RB were 98.3%, 97.8%, and 97.2%, respectively. The respective sensitivities were 96.1%, 94.1%, and 94.1%, while the specificities were found to be equal to 99.4%, 98.8%, and 97.5%, respectively. The study aims at showing that ANNs may prove useful in combination with other systems in providing diagnostic and predictive medical opinions. However, it must always be kept in mind that ANNs represent only one form of computer-aided diagnosis, and the clinician's responsibility and overall control of patient care should never be underestimated.

Prediction of Ferrite-Martensite Dual-Phase Steels Mechanical Properties by Use of Artificial Neural Networks

2013 ◽  
Vol 773-774 ◽  
pp. 268-274
Author(s):  
Amir Ghiami ◽  
Ramin Khamedi
Keyword(s):  
Mechanical Properties ◽  
Neural Networks ◽  
Artificial Neural Networks ◽  
Back Propagation ◽  
Total Elongation ◽  
Ultimate Tensile Stress ◽  
Dual Phase ◽  
Dual Phase Steels ◽  
Good Ability ◽  
Artificial Neural

This paper presents an investigation of the capabilities of artificial neural networks (ANN) in predicting some mechanical properties of Ferrite-Martensite dual-phase steels applicable for different industries like auto-making. Using ANNs instead of different destructive and non-destructive tests to determine the material properties, reduces costs and reduces the need for special testing facilities. Networks were trained with use of a back propagation (BP) error algorithm. In order to provide data for training the ANNs, mechanical properties, inter-critical annealing temperature and information about the microstructures of many specimens were examined. After the ANNs were trained, the four parameters of yield stress, ultimate tensile stress, total elongation and the work hardening exponent were simulated. Finally a comparison of the predicted and experimental values indicates that the results obtained from the given input data reveal a good ability of the well-trained ANN to predict the described mechanical properties.

Rainfall Prediction by Artificial Neural Networks Trained using Different Climate Variables

2021 ◽  
Author(s):  
Mateus Alexandre da Silva ◽  
Marina Neves Merlo ◽  
Michael Silveira Thebaldi ◽  
Danton Diego Ferreira ◽  
Felipe Schwerz ◽  
...  
Keyword(s):  
Neural Networks ◽  
Artificial Neural Networks ◽  
Input Data ◽  
Back Propagation ◽  
Metropolitan Region ◽  
Climate Variables ◽  
Back Propagation Algorithm ◽  
Rainfall Prediction ◽  
Artificial Neural ◽  
Belo Horizonte

Abstract Predicting rainfall can prevent and mitigate damages caused by its deficit or excess, besides providing necessary tools for adequate planning for the use of water. This research aimed to predict the monthly rainfall, one month in advance, in four municipalities in the metropolitan region of Belo Horizonte, using artificial neural networks (ANN) trained with different climate variables, and to indicate the suitability of such variables as inputs to these models. The models were developed through the MATLAB® software version R2011a, using the NNTOOL toolbox. The ANN’s were trained by the multilayer perceptron architecture and the Feedforward and Back propagation algorithm, using two combinations of input data were used, with 2 and 6 variables, and one combination of input data with 3 of the 6 variables most correlated to observed rainfall from 1970 to 1999, to predict the rainfall from 2000 to 2009. The most correlated variables to the rainfall of the following month are the sequential number corresponding to the month, total rainfall and average compensated temperature, and the best performance was obtained with these variables. Furthermore, it was concluded that the performance of the models was satisfactory; however, they presented limitations for predicting months with high rainfall.

Artificial neural networks back propagation algorithm for cutting force components predictions

2013 ◽  
Vol 14 (6) ◽  
pp. 431-439 ◽  
Author(s):  
Issam Hanafi ◽  
Francisco Mata Cabrera ◽  
Abdellatif Khamlichi ◽  
Ignacio Garrido ◽  
José Tejero Manzanares
Keyword(s):  
Neural Networks ◽  
Artificial Neural Networks ◽  
Cutting Force ◽  
Back Propagation ◽  
Back Propagation Algorithm ◽  
Propagation Algorithm ◽  
Cutting Force Components ◽  
Artificial Neural ◽  
Force Components
Sign in / Sign up

Export Citation Format

Share Document