Short‐term creep properties and creep model of wood‐plastic composites

2021 ◽  
Author(s):  
Longlong Zhao ◽  
Yang Wei ◽  
Guo Wei Zhang ◽  
Fei Xi
Keyword(s):  
Creep Model ◽  
Short Term ◽  
Wood Plastic Composites ◽  
Creep Properties ◽  
Plastic Composites ◽  
Term Creep ◽  
Short Term Creep

Microstructural stability and short-term creep properties of 12Cr–W–Mo–Co steel

2015 ◽  
Vol 622 ◽  
pp. 204-211 ◽  
Author(s):  
S.S. Wang ◽  
L. Chang ◽  
L. Wang ◽  
T. Wang ◽  
Y.D. Wu ◽  
...  
Keyword(s):  
Microstructural Stability ◽  
Short Term ◽  
Creep Properties ◽  
Term Creep ◽  
Short Term Creep

Experimental investigation of the hygrothermal creep strain of wood–plastic composite lumber made from thermally modified wood

2019 ◽  
Vol 33 (9) ◽  
pp. 1248-1268 ◽  
Author(s):  
Murtada Abass A Alrubaie ◽  
Roberto A Lopez-Anido ◽  
Douglas J Gardner ◽  
Mehdi Tajvidi ◽  
Yousoo Han
Keyword(s):  
Creep Strain ◽  
Water Immersion ◽  
Creep Recovery ◽  
Short Term ◽  
Creep Response ◽  
Plastic Composites ◽  
Thermally Modified Wood ◽  
Term Creep ◽  
Modified Wood ◽  
Short Term Creep

The hygrothermal effect on the short-term creep behavior of extruded thermally modified wood fiber–high-strength styrenic copolymer plastic composites (wood–plastic composites (WPCs)) was investigated on specimens preconditioned for 1 month under water immersion (distilled water (DW) and saltwater (SW)). These specimens were then tested in the same conditions for short-term creep and creep-recovery response using a submersible clamp. The short-term creep tests of WPC specimens (that are immersed in water as a function of different temperatures) have not yet been reported in previous studies. The objective of this study was to determine whether the hygrothermal creep response of WPC material evaluated through water immersion differs from the creep response published in the literature for other environmental exposure conditions. The experiments included measuring 30 min of creep and 30 min of creep recovery on the specimens immersed in SW and DW at two different levels of flexural stresses (9% and 14% of the flexural strength) and three temperature values (25, 35, and 45°C). The average creep strain recovery (%) of the specimens was higher for the specimens immersed in SW during testing than the control specimens. The WPC material is considered to have a potential use in structural applications in environments where the temperature is below 45°C because of the following factors: the low deformation under the short-term sustained loading, the decrease in the deformation rate with respect to the increase in load duration, maintaining the modulus of elasticity over a range of temperatures from 25°C to 45°C under sustained load, and the ability to recover more than 69% of the average creep strain under water immersion when the loading source is removed. The creep strain fractional increment (CSFI) of the WPC in this study under all conditions was 13% which is 86% lower than the CSFI of the WPCs reported in previous studies.

scholarly journals Short-term creep properties of Ti-6Al-4V alloy subjected to surface plasma carburizing process

2015 ◽  
Vol 4 (4) ◽  
pp. 359-366 ◽  
Author(s):  
Verônica Mara Cortez Alves de Oliveira ◽  
Mariane Capellari Leite da Silva ◽  
Cátia Gisele Pinto ◽  
Paulo Atsushi Suzuki ◽  
João Paulo Barros Machado ◽  
...  
Keyword(s):  
Surface Plasma ◽  
Short Term ◽  
Creep Properties ◽  
Term Creep ◽  
Plasma Carburizing ◽  
Carburizing Process ◽  
Short Term Creep

scholarly journals Short-term Creep Properties and Fracture Surface of 18 Ni (300) Maraging Steel Plasma Nitrided

2017 ◽  
Vol 20 (suppl 2) ◽  
pp. 2-9 ◽  
Author(s):  
Adriano Gonçalves dos Reis ◽  
Danieli Aparecida Pereira Reis ◽  
Antônio Jorge Abdalla ◽  
Antônio Augusto Couto ◽  
Jorge Otubo
Keyword(s):  
Fracture Surface ◽  
Maraging Steel ◽  
Short Term ◽  
Creep Properties ◽  
Term Creep ◽  
Short Term Creep

scholarly journals 38 Effects of combining nose flap weaning with short-term creep feeding of beef calves on cow and calf performance

2020 ◽  
Vol 98 (Supplement_3) ◽  
pp. 39-40
Author(s):  
Kendi Tjardes ◽  
Katy Lippolis
Keyword(s):  
Plasma Concentrations ◽  
Short Term ◽  
Beef Calves ◽  
Diarrhea Virus ◽  
Creep Feed ◽  
Calf Performance ◽  
Cow Performance ◽  
Term Creep ◽  
Viral Diarrhea Virus ◽  
Short Term Creep

Abstract One hundred four Angus calves were ranked by gender, BW, age, and dam parity, and assigned to 1 of 4 pre-weaning treatments: 1) nose flaps for 7-d prior to weaning (NF), 2) traditional weaning (TRAD), 3) traditional weaning and creep feed for 3-wk prior to weaning (TRADC), or 4) nose flaps for 7-d prior to weaning and creep feed for 3-wk prior to weaning (NFC). Cow-calf pairs were housed in dry lot pens on d -28. From d -21 to 0, calves in creep treatments were provided free choice access to creep feed. Nose flaps were placed on d -7, and calves were weaned on d 0. Calves were vaccinated and dewormed on d -21 and 0. There was no difference (P ≥ 0.97) in calf BW on d -28 or -21. During the 7-d period that nose flaps were placed, NFC calves had greater (P ≤ 0.0001) ADG than NF and TRAD calves, and tended to have greater (P ≤ 0.10) ADG than TRADC calves. At weaning on d 0, TRADC and NFC calves tended to have greater BW (P = 0.07) and had greater overall change in BW (P < 0.0001) during the pre-weaning period than TRAD and NF calves. Additionally, there was a greater (P ≤ 0.001) increase in BW of NFC and TRADC cows during the pre-weaning period compared to NF and TRAD cows. From d -21 to 0 there was no differences (P > 0.41) in plasma concentrations for Bovine Viral Diarrhea Virus (BVD). By d 14, the TRADC calves had the greatest plasma concentrations for BVD (P < 0.04). Therefore, providing short-term creep feed prior to placing nose flaps can improve pre-weaning calf and cow performance compared to traditional and nose flap weaning without creep feed supplementation, however, did not improve response to vaccination.

scholarly journals Experimental investigation of the short-term creep recovery of hardened cement paste at micrometre length scale

2021 ◽  
Vol 149 ◽  
pp. 106562
Author(s):  
Yidong Gan ◽  
Matthieu Vandamme ◽  
Yu Chen ◽  
Erik Schlangen ◽  
Klaas van Breugel ◽  
...  
Keyword(s):  
Experimental Investigation ◽  
Cement Paste ◽  
Creep Recovery ◽  
Hardened Cement ◽  
Length Scale ◽  
Hardened Cement Paste ◽  
Short Term ◽  
Term Creep ◽  
Short Term Creep

Prediction of Long Term Stress Rupture Data for 2124

2006 ◽  
Vol 519-521 ◽  
pp. 1041-1046 ◽  
Author(s):  
Brian Wilshire ◽  
H. Burt ◽  
N.P. Lavery
Keyword(s):  
Q Methodology ◽  
Fracture Behavior ◽  
Stress Rupture ◽  
Creep Data ◽  
Short Term ◽  
Rupture Data ◽  
Term Creep ◽  
Term Data ◽  
Short Term Creep

The standard power law approaches widely used to describe creep and creep fracture behavior have not led to theories capable of predicting long-term data. Similarly, traditional parametric methods for property rationalization also have limited predictive capabilities. In contrast, quantifying the shapes of short-term creep curves using the q methodology introduces several physically-meaningful procedures for creep data rationalization and prediction, which allow straightforward estimation of the 100,000 hour stress rupture values for the aluminum alloy, 2124.

Microstructural evolution of delta ferrite in SAVE12 steel under heat treatment and short-term creep

2012 ◽  
Vol 73 ◽  
pp. 144-152 ◽  
Author(s):  
Shengzhi Li ◽  
Zumrat Eliniyaz ◽  
Lanting Zhang ◽  
Feng Sun ◽  
Yinzhong Shen ◽  
...  
Keyword(s):  
Heat Treatment ◽  
Microstructural Evolution ◽  
Short Term ◽  
Delta Ferrite ◽  
Term Creep ◽  
Short Term Creep

Short-Term Creep Data Based Long-Term Creep Life Predictability for Grade 92 Steels and Its Microstructural Basis

2018 ◽  
Vol 25 (3) ◽  
pp. 713-722 ◽  
Author(s):  
Seen Chan Kim ◽  
Jae-Hyeok Shim ◽  
Woo-Sang Jung ◽  
Yoon Suk Choi
Keyword(s):  
Creep Data ◽  
Creep Life ◽  
Short Term ◽  
Term Creep ◽  
Short Term Creep
Sign in / Sign up

Export Citation Format

Share Document