Mechanism of Peroxide Cross-Linking of EPDM Rubber

2010 ◽  
Vol 291-292 (1) ◽  
pp. 66-74 ◽  
Author(s):  
Martin van Duin ◽  
Ramona Orza ◽  
Ron Peters ◽  
Victor Chechik
Keyword(s):  
Cross Linking ◽  
Epdm Rubber

Mechanism for Peroxide Cross-Linking of EPDM Rubber from MAS13C NMR Spectroscopy

2009 ◽  
Vol 42 (22) ◽  
pp. 8914-8924 ◽  
Author(s):  
R. A. Orza ◽  
P. C. M. M. Magusin ◽  
V. M. Litvinov ◽  
M. van Duin ◽  
M. A. J. Michels
Keyword(s):  
Nmr Spectroscopy ◽  
Cross Linking ◽  
Epdm Rubber

scholarly journals A Method to Improve the Characteristics of EPDM Rubber Based Eco-Composites with Electron Beam

Polymers ◽  
2020 ◽  
Vol 12 (1) ◽  
pp. 215 ◽  
Author(s):  
Gabriela Craciun ◽  
Elena Manaila ◽  
Daniel Ighigeanu ◽  
Maria Daniela Stelescu
Keyword(s):  
Electron Beam ◽  
Electron Beam Irradiation ◽  
Natural Fiber ◽  
Sol Gel ◽  
Mechanical Tests ◽  
Cross Linking ◽  
Atmospheric Conditions ◽  
Epdm Rubber ◽  
Reinforced Composite ◽  
Physical And Chemical

A natural fiber reinforced composite, belonging to the class of eco composites, based on ethylene-propylene-terpolymer rubber (EPDM) and wood wastes were obtained by electron beam irradiation at 75, 150, 300, and 600 kGy in atmospheric conditions and at room temperature using a linear accelerator of 5.5 MeV. The sawdust (S), in amounts of 5 and 15 phr, respectively, was used to act as a natural filler for the improvement of physical and chemical characteristics. The cross-linking effects were evaluated through sol-gel analysis, mechanical tests, and Fourier Transform Infrared FTIR spectroscopy comparatively with the classic method with dibenzoyl peroxide (P) applied on the same types of samples at high temperature. Gel fraction exhibits values over 98% but, in the case of P cross-linking, is necessary to add more sawdust (15 phr) to obtain the same results as in the case of electron beam (EB) cross-linking (5 phr/300 kGy). Even if the EB cross-linking and sawdust addition have a reinforcement effect on EPDM rubber, the medium irradiation dose of 300 kGy looks to be a limit to which or from which the properties of the composite are improved or deteriorated. The absorption behavior of the eco-composites was studied through water uptake tests.

Mechanically Robust and Recyclable EPDM Rubber Composites by a Green Cross-Linking Strategy

2019 ◽  
Vol 7 (13) ◽  
pp. 11712-11720 ◽  
Author(s):  
Ganggang Zhang ◽  
Xinxin Zhou ◽  
Kuan Liang ◽  
Baochun Guo ◽  
Xiaolin Li ◽  
...  
Keyword(s):  
Cross Linking ◽  
Rubber Composites ◽  
Epdm Rubber

scholarly journals Poultry Feather Waste as Bio-Based Cross-Linking Additive for Ethylene Propylene Diene Rubber

Polymers ◽  
2021 ◽  
Vol 13 (22) ◽  
pp. 3908
Author(s):  
Markus Brenner ◽  
Oliver Weichold
Keyword(s):  
Carbon Black ◽  
High Volume ◽  
Cross Linking ◽  
Epdm Rubber ◽  
Feather Waste ◽  
Degradation Step ◽  
Ethylene Propylene Diene Rubber ◽  
Poultry Feather ◽  
Diene Rubber ◽  
Thermal Stability Of

Most rubbers used today rely on sulphur as a cross-linking agent and carbon black from fossil resources to modify the mechanical properties. A very promising substitute can be found in natural keratins such as feathers. These are not only tough, but also contain a relevant amount of sulphur in the form of disulphide bridges. The present study shows that these can be activated under vulcanisation conditions and then bind covalently to EPDM rubber to form a cross-linked network. Feathers were cut into lengths of 0.08, 0.2, and 1 mm and incorporated at 38, 69, or 100 phr into EPDM mixtures containing either no carbon black or no carbon black nor sulphur. The presence of feather cuttings increases the tensile and compressive strength as well as the hardness, and reduces the rebound resilience. Due to their high (approximately 17%) nitrogen content, the feathers also improve the thermal stability of the composite, as the main degradation step is shifted from 400 °C to 470 °C and the decomposition is significantly slowed down. Since elastomers are a large market and feathers in particular are a high-volume waste, the combination of these two offers enormous ecological and economic prospects.

NMR measurements of gaseous sulfur hexafluoride (SF6) to probe the cross-linking of EPDM rubber

2005 ◽  
Vol 43 (11) ◽  
pp. 926-936 ◽  
Author(s):  
M. Terekhov ◽  
S. Neutzler ◽  
M. Aluas ◽  
D. Hoepfel ◽  
L. R. Oellrich
Keyword(s):  
Sulfur Hexafluoride ◽  
Cross Linking ◽  
Epdm Rubber ◽  
The Cross ◽  
Gaseous Sulfur

Influence of Calcium Ions on the Plant Cell Surface: Membrane Fusions and Conformational Changes

1974 ◽  
Vol 32 ◽  
pp. 154-155
Author(s):  
D. James Morré ◽  
Charles E. Bracker ◽  
William J. VanDerWoude
Keyword(s):  
Cell Wall ◽  
Cell Surface ◽  
Conformational Changes ◽  
Calcium Ions ◽  
Surface Membrane ◽  
Carboxyl Groups ◽  
Cross Linking ◽  
Ultrastructural Evidence ◽  
Glycine Max L ◽  
Wall Extensibility

Calcium ions in the concentration range 5-100 mM inhibit auxin-induced cell elongation and wall extensibility of plant stems. Inhibition of wall extensibility requires that the tissue be living; growth inhibition cannot be explained on the basis of cross-linking of carboxyl groups of cell wall uronides by calcium ions. In this study, ultrastructural evidence was sought for an interaction of calcium ions with some component other than the wall at the cell surface of soybean (Glycine max (L.) Merr.) hypocotyls.

Embedding Procedure for Water Swollen Samples

1970 ◽  
Vol 28 ◽  
pp. 504-505
Author(s):  
Ann M. Thomas ◽  
Virginia Shemeley
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Ion Exchange ◽  
Structural Changes ◽  
Cross Linking ◽  
Ion Exchange Resins ◽  
Transmission Electron ◽  
First Pass ◽  
Exchange Resins

Those samples which swell rapidly when exposed to water are, at best, difficult to section for transmission electron microscopy. Some materials literally burst out of the embedding block with the first pass by the knife, and even the most rapid cutting cycle produces sections of limited value. Many ion exchange resins swell in water; some undergo irreversible structural changes when dried. We developed our embedding procedure to handle this type of sample, but it should be applicable to many materials that present similar sectioning difficulties.The purpose of our embedding procedure is to build up a cross-linking network throughout the sample, while it is in a water swollen state. Our procedure was suggested to us by the work of Rosenberg, where he mentioned the formation of a tridimensional structure by the polymerization of the GMA biproduct, triglycol dimethacrylate.

The Current Situation in Chemical Stabilization of Biological Materials

1972 ◽  
Vol 30 ◽  
pp. 132-133
Author(s):  
John H. Luft
Keyword(s):  
Electron Microscopy ◽  
Electron Microscope ◽  
Osmium Tetroxide ◽  
Molecular Level ◽  
Cross Linking ◽  
Chemical Stabilization ◽  
Specimen Preparation ◽  
Sufficient Condition ◽  
Radio Telescopes

With information processing devices such as radio telescopes, microscopes or hi-fi systems, the quality of the output often is limited by distortion or noise introduced at the input stage of the device. This analogy can be extended usefully to specimen preparation for the electron microscope; fixation, which initiates the processing sequence, is the single most important step and, unfortunately, is the least well understood. Although there is an abundance of fixation mixtures recommended in the light microscopy literature, osmium tetroxide and glutaraldehyde are favored for electron microscopy. These fixatives react vigorously with proteins at the molecular level. There is clear evidence for the cross-linking of proteins both by osmium tetroxide and glutaraldehyde and cross-linking may be a necessary if not sufficient condition to define fixatives as a class.

Parathyroid gland before and after cisplatin treatment

1987 ◽  
Vol 45 ◽  
pp. 860-861
Author(s):  
S.K. Aggarwal ◽  
J.M. Fadool
Keyword(s):  
Parathyroid Gland ◽  
Wistar Rats ◽  
Antitumor Agent ◽  
The Body ◽  
Cross Linking ◽  
Limiting Factor ◽  
Hormonal Changes ◽  
Primary Mechanism ◽  
Before And After ◽  
Dna Strands

Cisplatin (CDDP) a potent antitumor agent suffers from severe toxic side effects with nephrotoxicity being the major dose-limiting factor, The primary mechanism of its action has been proposed to be through its cross-linking DNA strands. It has also been shown to inactivate various transport enzymes and induce hypocalcemia and hypomagnesemia that may be the underlying cause for some of its toxicities. The present is an effort to study its influence on the parathyroid gland for any hormonal changes that control calcium levels in the body.Male Swiss Wistar rats (Crl: (WI) BR) weighing 200-300 g and of 60 days in age were injected (ip) with cisplatin (7mg/kg in normal saline). The controls received saline injections only. The animals were injected (iv) with calcium (0.5 ml of 10% calcium gluconate/day) and were killed by decapitation on day 1 through 5. Trunk blood was collected in heparinized tubes.

Large-cluster and combined fluorescent and gold immunoprobes

1996 ◽  
Vol 54 ◽  
pp. 892-893
Author(s):  
Richard D. Powell ◽  
James F. Hainfeld ◽  
Carol M. R. Halsey ◽  
David L. Spector ◽  
Shelley Kaurin ◽  
...  
Keyword(s):  
Metal Cluster ◽  
Sulfonyl Chloride ◽  
Gel Filtration ◽  
Cross Linking ◽  
Site Specific ◽  
Fab Fragments ◽  
Cluster Label ◽  
Covalently Linked ◽  
Texas Red ◽  
Fold Excess

Two new types of covalently linked, site-specific immunoprobes have been prepared using metal cluster labels, and used to stain components of cells. Combined fluorescein and 1.4 nm “Nanogold” labels were prepared by using the fluorescein-conjugated tris (aryl) phosphine ligand and the amino-substituted ligand in the synthesis of the Nanogold cluster. This cluster label was activated by reaction with a 60-fold excess of (sulfo-Succinimidyl-4-N-maleiniido-cyclohexane-l-carboxylate (sulfo-SMCC) at pH 7.5, separated from excess cross-linking reagent by gel filtration, and mixed in ten-fold excess with Goat Fab’ fragments against mouse IgG (obtained by reduction of F(ab’)2 fragments with 50 mM mercaptoethylamine hydrochloride). Labeled Fab’ fragments were isolated by gel filtration HPLC (Superose-12, Pharmacia). A combined Nanogold and Texas Red label was also prepared, using a Nanogold cluster derivatized with both and its protected analog: the cluster was reacted with an eight-fold excess of Texas Red sulfonyl chloride at pH 9.0, separated from excess Texas Red by gel filtration, then deprotected with HC1 in methanol to yield the amino-substituted label.

Sign in / Sign up

Export Citation Format

Share Document