Comparison of methods for area-averaging surface energy fluxes over heterogeneous land surfaces using high-resolution non-hydrostatic simulations

2005 ◽  
Vol 25 (3) ◽  
pp. 379-403 ◽  
Author(s):  
Günther Heinemann ◽  
Michael Kerschgens
Keyword(s):  
High Resolution ◽  
Surface Energy ◽  
Comparison Of Methods ◽  
Energy Fluxes ◽  
Surface Energy Fluxes ◽  
Land Surfaces

scholarly journals Surface energy fluxes over El Reno, Oklahoma, using high-resolution remotely sensed data

2003 ◽  
Vol 39 (6) ◽  
Author(s):  
Andrew N. French ◽  
Thomas J. Schmugge ◽  
William P. Kustas ◽  
Kaye L. Brubaker ◽  
John Prueger
Keyword(s):  
High Resolution ◽  
Surface Energy ◽  
Remotely Sensed ◽  
Energy Fluxes ◽  
Remotely Sensed Data ◽  
Surface Energy Fluxes

scholarly journals Comparison of FASST and SNTHERM in Three Snow Accumulation Regimes

2008 ◽  
Vol 9 (6) ◽  
pp. 1443-1463 ◽  
Author(s):  
Susan Frankenstein ◽  
Anne Sawyer ◽  
Julie Koeberle
Keyword(s):  
Surface Energy ◽  
Single Layer ◽  
Soil Strength ◽  
Snow Accumulation ◽  
Dynamic State ◽  
Energy Fluxes ◽  
One Dimensional ◽  
Surface Energy Fluxes ◽  
Snow Model ◽  
Surface Ice

Abstract Numerical experiments of snow accumulation and depletion were carried out as well as surface energy fluxes over four Cold Land Processes Experiment (CLPX) sites in Colorado using the Snow Thermal model (SNTHERM) and the Fast All-Season Soil Strength model (FASST). SNTHERM is a multilayer snow model developed to describe changes in snow properties as a function of depth and time, using a one-dimensional mass and energy balance. The model is intended for seasonal snow covers and addresses conditions found throughout the winter, from initial ground freezing in the fall to snow ablation in the spring. It has been used by many researchers over a variety of terrains. FASST is a newly developed one-dimensional dynamic state-of-the-ground model. It calculates the ground’s moisture content, ice content, temperature, and freeze–thaw profiles as well as soil strength and surface ice and snow accumulation/depletion. Because FASST is newer and not as well known, the authors wanted to determine its use as a snow model by comparing it with SNTHERM, one of the most established snow models available. It is demonstrated that even though FASST is only a single-layer snow model, the RMSE snow depth compared very favorably against SNTHERM, often performing better during the accumulation phase. The surface energy fluxes calculated by the two models were also compared and were found to be similar.

scholarly journals Simulated Sensitivity of Tropical Cyclone Size and Structure to the Atmospheric Temperature Profile

2016 ◽  
Vol 73 (11) ◽  
pp. 4553-4571 ◽  
Author(s):  
Diana R. Stovern ◽  
Elizabeth A. Ritchie
Keyword(s):  
Tropical Cyclone ◽  
Surface Energy ◽  
Temperature Profile ◽  
Convective Available Potential Energy ◽  
Atmospheric Temperature ◽  
Outer Core ◽  
Specific Humidity ◽  
Energy Fluxes ◽  
Surface Energy Fluxes ◽  
Size And Structure

Abstract This study uses the WRF ARW to investigate how different atmospheric temperature environments impact the size and structure development of a simulated tropical cyclone (TC). In each simulation, the entire vertical virtual temperature profile is either warmed or cooled in 1°C increments from an initial specified state while the initial relative humidity profile and sea surface temperature are held constant. This alters the initial amount of convective available potential energy (CAPE), specific humidity, and air–sea temperature difference such that, when the simulated atmosphere is cooled (warmed), the initial specific humidity and CAPE decrease (increase), but the surface energy fluxes from the ocean increase (decrease). It is found that the TCs that form in an initially cooler environment develop larger wind and precipitation fields with more active outer-core rainband formation. Consistent with previous studies, outer-core rainband formation is associated with high surface energy fluxes, which leads to increases in the outer-core wind field. A larger convective field develops despite initializing in a low CAPE environment, and the dynamics are linked to a wider field of surface radial inflow. As the TC matures and radial inflow expands, large imports of relative angular momentum in the boundary layer continue to drive expansion of the TC’s overall size.

Sign in / Sign up

Export Citation Format

Share Document