Simple two‐stage weighting factor design for finite control set model predictive control of modular multilevel converters

2021 ◽  
Author(s):  
Mahyar Khosravi ◽  
Davood Arab Khaburi ◽  
Jose Rodriguez
Keyword(s):  
Model Predictive Control ◽  
Predictive Control ◽  
Weighting Factor ◽  
Two Stage ◽  
Multilevel Converters ◽  
Modular Multilevel Converters ◽  
Finite Control ◽  
Factor Design ◽  
Control Set

scholarly journals Fault Analysis and Non-Redundant Fault Tolerance in 3-Level Double Conversion UPS Systems Using Finite-Control-Set Model Predictive Control

Energies ◽  
2021 ◽  
Vol 14 (8) ◽  
pp. 2210
Author(s):  
Luís Caseiro ◽  
André Mendes
Keyword(s):  
Fault Tolerance ◽  
Model Predictive Control ◽  
Predictive Control ◽  
Fault Tolerant ◽  
Finite Control ◽  
Control Set ◽  
Corrective Actions ◽  
Uninterruptible Power ◽  
Hardware Reconfiguration ◽  
Redundant Fault

Fault-tolerance is critical in power electronics, especially in Uninterruptible Power Supplies, given their role in protecting critical loads. Hence, it is crucial to develop fault-tolerant techniques to improve the resilience of these systems. This paper proposes a non-redundant fault-tolerant double conversion uninterruptible power supply based on 3-level converters. The proposed solution can correct open-circuit faults in all semiconductors (IGBTs and diodes) of all converters of the system (including the DC-DC converter), ensuring full-rated post-fault operation. This technique leverages the versatility of Finite-Control-Set Model Predictive Control to implement highly specific fault correction. This type of control enables a conditional exclusion of the switching states affected by each fault, allowing the converter to avoid these states when the fault compromises their output but still use them in all other conditions. Three main types of corrective actions are used: predictive controller adaptations, hardware reconfiguration, and DC bus voltage adjustment. However, highly differentiated corrective actions are taken depending on the fault type and location, maximizing post-fault performance in each case. Faults can be corrected simultaneously in all converters, as well as some combinations of multiple faults in the same converter. Experimental results are presented demonstrating the performance of the proposed solution.

Sign in / Sign up

Export Citation Format

Share Document