Influence of moisture content on the specific methanogenic activity of dry mesophilic municipal solid waste digestate

2011 ◽  
Vol 87 (7) ◽  
pp. 1032-1035 ◽  
Author(s):  
Ronan Le Hyaric ◽  
Hassen Benbelkacem ◽  
Julien Bollon ◽  
Rémy Bayard ◽  
Renaud Escudié ◽  
...  
Keyword(s):  
Moisture Content ◽  
Municipal Solid Waste ◽  
Solid Waste ◽  
Methanogenic Activity ◽  
Specific Methanogenic Activity

Municipal solid waste in situ moisture content measurement using an electrical resistance sensor

2003 ◽  
Vol 23 (7) ◽  
pp. 667-674 ◽  
Author(s):  
Nitin A. Gawande ◽  
Debra R. Reinhart ◽  
Philip A. Thomas ◽  
Philip T. McCreanor ◽  
Timothy G. Townsend
Keyword(s):  
Moisture Content ◽  
Municipal Solid Waste ◽  
Solid Waste ◽  
Electrical Resistance ◽  
Content Measurement ◽  
Moisture Content Measurement

Effect of aeration rate and moisture content on the emissions of selected VOCs during municipal solid waste composting

2012 ◽  
Vol 14 (4) ◽  
pp. 371-378 ◽  
Author(s):  
M. Delgado-Rodríguez ◽  
M. Ruiz-Montoya ◽  
I. Giraldez ◽  
R. López ◽  
E. Madejón ◽  
...  
Keyword(s):  
Moisture Content ◽  
Municipal Solid Waste ◽  
Solid Waste ◽  
Aeration Rate

Autothermal biodrying of municipal solid waste with high moisture content

2010 ◽  
Vol 64 (2) ◽  
Author(s):  
Agnieszka Zawadzka ◽  
Liliana Krzystek ◽  
Stanisław Ledakowicz
Keyword(s):  
Moisture Content ◽  
Municipal Solid Waste ◽  
Solid Waste ◽  
Energy Content ◽  
Plastic Material ◽  
Initial Moisture Content ◽  
Tubular Reactor ◽  
Calorific Value ◽  
High Energy ◽  
Total Capacity

AbstractTo carry out autothermal drying processes during the composting of biomass, a horizontal tubular reactor was designed and tested. A biodrying tunnel of the total capacity of 240 dm3 was made of plastic material and insulated with polyurethane foam to prevent heat losses. Municipal solid waste and structural plant material were used as the input substrate. As a result of autothermal drying processes, moisture content decreased by 50 % of the initial moisture content of organic waste of about 800 g kg−1. In the tested cycles, high temperatures of biodried waste mass were achieved (54–56°C). An appropriate quantity of air was supplied to maintain a satisfactory level of temperature and moisture removal in the biodried mass and high energy content in the final product. The heat of combustion of dried waste and its calorific value were determined in a calorimeter. Examinations of pyrolysis and gasification of dried waste confirmed their usefulness as biofuel of satisfactory energy content.

Anaerobic Digestion of Olive Oil Mill Effluent Pretreated and Stored in Municipal Solid Waste Sanitary Landfills

1993 ◽  
Vol 28 (2) ◽  
pp. 27-34 ◽  
Author(s):  
G. Boari ◽  
I. M. Mancini ◽  
E. Trulli
Keyword(s):  
Anaerobic Digestion ◽  
Municipal Solid Waste ◽  
Olive Oil ◽  
Solid Waste ◽  
Pilot Scale ◽  
Methanogenic Activity ◽  
Sanitary Landfills ◽  
Olive Oil Mill Effluent ◽  
A Cell ◽  
Mesh Sieve

Sanitary landfills of municipal solid waste (MSW) might be used to reduce the storage volume required at plants giving year-round treatment of olive oil mill effluent (OME). A landfill in the methanogenic stage could act as an anaerobic filter and reduce the pollutional load of the OME while also acting as a temporary storage tank. In the present work, a lysimeter in pilot scale was used to simulate a cell of a sanitary landfill. It was filled with MSW screened by a 80 mm mesh sieve mixed to municipal sludge. Results show that when OME was spread on the top of the lysimeter at a loading rate not exceeding 0.4 kgCOD/d/m3 of reactor steady methanogenic activity was maintained in the layers of refuse and a 70% removal of COD was obtained in the OME leachate collected. Higher loading rates reduced methanogenic activity and COD removal efficiency. Nevertheless, the OME collected from the bottom of the landfill was more easily treated by anaerobic digestion than was the raw OME.

scholarly journals Effect Of Water Content On Characteristics Fuel From The Municipal Solid Waste Through The Pyrolysis Process

2021 ◽  
Vol 5 (2) ◽  
pp. 9-16
Author(s):  
Imron Rosyadi ◽  
Ni Ketut Caturwati ◽  
Ahmad Fauzi
Keyword(s):  
Moisture Content ◽  
Municipal Solid Waste ◽  
Solid Waste ◽  
Water Content ◽  
Biomass Conversion ◽  
Calorific Value ◽  
Treatment Method ◽  
Volatile Matter ◽  
Average Error ◽  
Rice Samples

The increase in the population of Indonesia is proportional to the increase in the amount of waste produced. Municipal solid waste (MSW) especially organic waste, can be used as solid fuel by means of the torefaction process. Torefaction is a thermo-chemical heat treatment method for biomass conversion that takes place at a temperature of 200oC to 300oC under conditions of atmospheric pressure and in the absence of oxygen. The purpose of this study was to determine the effect of moisture content on calorific, proximate and ultimate values ​​of torefaction samples using municipal solid waste. Setting the water content in the mixed sample (30% rice + 70% wood) with variations in moisture content of 30%, 40%, and 50%; and rice and wood samples with variations in moisture content of 40% and 50%. The torefaction was carried out at a temperature of 300oC for one hour and  inert gas  N2. Torefaction products have been tested contain of the calorific value, proximate testing, and ultimate testing. The results obtained were the best calorific value in the rice sample, the moisture content of 40% was 6351.1 cal / g or equivalent to sub-bituminous coal. The proximate and ultimate results of the best heating value are rice samples with 40% moisture content, fixed carbon 62.95%, volatile matter 27.85%, moisture 7.06%, ash 2.14%, carbon 71.85%, hydrogen. 2.80%, nitrogen 3.17%, and sulfur 0.05%. The calorific value calculation method that is almost close to the test results is the Dulong method, with an average error percentage of 1.63%.

Sign in / Sign up

Export Citation Format

Share Document