THE EFFECT OF DRIP LINE PLACEMENT ON SOIL WATER DYNAMICS IN THE CASE OF SURFACE AND SUBSURFACE DRIP IRRIGATION

2012 ◽  
Vol 61 (5) ◽  
pp. 622-630 ◽  
Author(s):  
E. Diamantopoulos ◽  
S. Elmaloglou
Keyword(s):  
Soil Water ◽  
Drip Irrigation ◽  
Drip Line ◽  
Water Dynamics ◽  
Subsurface Drip Irrigation ◽  
Soil Water Dynamics ◽  
Line Placement ◽  
Subsurface Drip

Effects of Dripper Discharge and Irrigation Amount on Soil-Water Dynamics under Subsurface Drip Irrigation

2011 ◽  
Vol 347-353 ◽  
pp. 2400-2403 ◽  
Author(s):  
Xiao Ning Mei ◽  
Zhen Zhong Shen ◽  
Jie Ren ◽  
Zhen Hua Wang
Keyword(s):  
Soil Water ◽  
Drip Irrigation ◽  
Water Dynamics ◽  
Subsurface Drip Irrigation ◽  
Design Parameters ◽  
Wetting Front ◽  
Soil Water Dynamics ◽  
Irrigation Amount ◽  
Irrigation Design ◽  
Subsurface Drip

Subsurface drip irrigation (SDI) that has a wide application prospect is one of the high efficiency water-saving irrigation techniques. Research on regulation of soil-water dynamics in irrigation design parameters of SDI has important points in improving its irrigation design and guiding its practical function. In this study, soil wetting patterns were investigated in laboratory experiments which were operated at three different dripper discharges (0.76, 1.15 and 1.25 l h-1) and two different irrigation amounts (4.6 and 9.2 l). The results showed that, (1) with the increase of dripper discharges from 0.76 l h-1 to 1.25 l h-1, water content around the emitter are increasing from 0.225 cm3 cm-3 to 0.300 cm3 cm-3, (2) increasing the dripper discharge and irrigation amount increased the size of the wetted zone, (3) upward distance of the wetting front is less than downward distance and horizontal distance of the wetting front presents symmetry distribution at the same the dripper discharges and irrigation amount, (4) with the increase of irrigation amounts from 4.6 l to 9.2 l, water contents of the vertical and horizontal direction are increasing 10% to 20%.

scholarly journals Parameterization of Soil Hydraulic Parameters for HYDRUS-3D Simulation of Soil Water Dynamics in a Drip-Irrigated Orchard

Water ◽  
2020 ◽  
Vol 12 (7) ◽  
pp. 1858 ◽  
Author(s):  
Jesús María Domínguez-Niño ◽  
Gerard Arbat ◽  
Iael Raij-Hoffman ◽  
Isaya Kisekka ◽  
Joan Girona ◽  
...  
Keyword(s):  
Soil Moisture ◽  
Soil Water ◽  
Drip Irrigation ◽  
Water Dynamics ◽  
Hydraulic Parameters ◽  
Soil Water Dynamics ◽  
Heterogeneous Distribution ◽  
Neutron Probe ◽  
Soil Hydraulic Parameters ◽  
Soil Hydraulic

Although surface drip irrigation allows an efficient use of water in agriculture, the heterogeneous distribution of soil water complicates its optimal usage. Mathematical models can be used to simulate the dynamics of water in the soil below a dripper and promote: a better understanding, and optimization, of the design of drip irrigation systems, their improved management and their monitoring with soil moisture sensors. The aim of this paper was to find the most appropriate configuration of HYDRUS-3D for simulating the soil water dynamics in a drip-irrigated orchard. Special emphasis was placed on the source of the soil hydraulic parameters. Simulations parameterized using the Rosetta approach were therefore compared with others parameterized using that of HYPROP + WP4C. The simulations were validated on a seasonal scale, against measurements made using a neutron probe, and on the time course of several days, against tensiometers. The results showed that the best agreement with soil moisture measurements was achieved with simulations parameterized from HYPROP + WP4C. It further improved when the shape parameter n was empirically calibrated from a subset of neutron probe measurements. The fit of the simulations with measurements was best at positions near the dripper and worsened at positions outside its wetting pattern and at depths of 80 cm or more.

Multiscaling analysis of Soil Water Content during irrigation events. Comparison between surface and subsurface drip irrigation

Geoderma ◽  
2021 ◽  
Vol 382 ◽  
pp. 114777
Author(s):  
Leonor Rodríguez-Sinobas ◽  
Sergio Zubelzu ◽  
Juan J. Martín-Sotoca ◽  
Ana M. Tarquis
Keyword(s):  
Water Content ◽  
Soil Water ◽  
Soil Water Content ◽  
Drip Irrigation ◽  
Subsurface Drip Irrigation ◽  
Subsurface Drip

scholarly journals Effect of mulching and subsurface drip irrigation on soil water status under arid environment

2020 ◽  
Vol 18 (1) ◽  
pp. e1201
Author(s):  
Ahmed A. Al-Othman ◽  
Mohamed A. Mattar ◽  
Mohammed A. Alsamhan
Keyword(s):  
Soil Water ◽  
Drip Irrigation ◽  
Agricultural Research ◽  
Water Status ◽  
Soil Surface ◽  
Subsurface Drip Irrigation ◽  
Water Evaporation ◽  
Water Retention Capacity ◽  
Palm Tree ◽  
Subsurface Drip

Aim of study: We investigated water evaporation of the soil surface and the soil water distribution under different mulching techniques using subsurface drip irrigation (SDI) system.Area of study: The experiment was conducted at the Agricultural Research and Experimental Farm in Dirab, Riyadh, Saudi Arabia, locating 24.4195° N, 46.65° E, and 552 m altitude.Material and methods: The two types of soil surface mulching were black plastic film (BPF) and palm tree waste (PTW), with no mulching (NM) as control. The two drip line depths from the soil surface (DL) were 15 cm and 25 cm, and surface drip irrigation (DI) was the control.Main results: In SDI, the use of BPF or PTW mulching resulted in enhanced water retention capacity of the soil and an approximately 6% water saving, compared with NM. The amounts of water saved at DL of 15 cm (19-24 mm) were greater than those at DL of 25 cm (15-20 mm), whereas the DI used the highest amount of applied water. The distribution of soil water content for BPF and PTW were found to be more uniform than NM.Research highlights: It is advised to mulch the soil with PTW due to lower costs and through a DL of 15 cm.

scholarly journals Aspects of formation of soil water regime and water consumption of corn under subsurface drip irrigation

2021 ◽  
pp. 190-200
Author(s):  
M. I. Romashchenko ◽  
A. P. Shatkovskyi ◽  
A. S. Sardak ◽  
Y. A. Cherevichny ◽  
N. A. Didenko ◽  
...  
Keyword(s):  
Soil Water ◽  
Water Consumption ◽  
Drip Irrigation ◽  
Water Regime ◽  
Soil Surface ◽  
Subsurface Drip Irrigation ◽  
Corn Yield ◽  
Consumption Ratio ◽  
Soil Water Regime ◽  
Subsurface Drip

The results of experimental researches on studying of features of formation of a water mode of soils, water consumption processes, and corn yield under different schemes of irrigation pipelines (IP) under subsurface drip irrigation (SDI) in the Steppe of Ukraine. The wetting zone of dark-chestnut residual-saline sandy soil (SI "SF "Brylivske") changed. There is a shift of the center relative to the drip water outlet into deeper horizons of the soil profile (up to 52 cm) with the increasing norm; soil layer 0-15 cm is almost not moistened, regardless of watering rate. At a distance of IP 1,0 m closing of wetting zones, occur at irrigation rates of 2,7 m3/100 running meter (r. m), and at a distance of IP 1,4 m does not occur even at irrigation rates of 3,7 m3/100 r. m, while the depth of wetting reaches 90 cm. The wetting zone of chernozem sandy loam on the loess species (SI "SF "Velyki Klyny") with irrigation rates of 2,7 m3/100 r. m was observed on the soil surface. The maximum depth of wetting, with irrigation norms of 3,7 m3/100 r. m, reached 70 cm with a maximum diameter of 79 cm at a depth of 25 cm. Closing of wetting zones was not observed. Studies at SI "SF "Brylivske" have confirmed that the depth of IP placement (on the soil surface or at a depth of 30 cm) influenced the formation of the soil water regime and the corn yield. The minimum total water consumption was 6271 m3/ha under drip irrigation (DI) (IP 1,4 m), 17 % more than SDI (IP 1,4 m), and 29% more than SDI (IP 1,0 m). The highest yield was obtained in the case of DI (IP 1,4 m) of 15,72 t/ha. SDI (IP 1,0 m) received 13,93 t/ha, and SDI (IP 1,4 m) received 13,50 t/ha. The distance between the IP in 1,0 m and 1.4 m of the SDI system did not significantly affect corn yield (13.93 and 13.50 t/ha, respectively), but at a distance of IP 1.4 m, the water consumption ratio was 6.8% less compared to IP 1,0 m. The value of the irrigation rate in the variants SDI (IP 1.0 m) was higher than SDI (IP 1,4 m) by 13,6 %. Therefore, in terms of irrigation water consumption and capital expenditures, the SDI (IP 1,4 m) is more economical. Experimental studies conducted in the SI "SF "Velyki Klyny" show that the depth of placement of IP (on the soil surface or at a depth of 20 cm) did not affect the corn yield. For DI (IP 1,0 m) the yield was 12,00 t/ha and for SDI (IP 1.0 m) was 12,10 t/ha, with a water consumption ratio of 533,8 m3/t, and for DI (IP 1,0 m) by 3,6 % more. The research results confirm the importance of the parameters of SDI system for the formation of soil water regime and, accordingly, the realization of the potential of varieties and hybrids of crops for their cultivation by SDI.

scholarly journals Modeling Approaches for Determining Dripline Depth and Irrigation Frequency of Subsurface Drip Irrigated Rice on Different Soil Textures

Water ◽  
2020 ◽  
Vol 12 (6) ◽  
pp. 1724
Author(s):  
Gerard Arbat ◽  
Sílvia Cufí ◽  
Miquel Duran-Ros ◽  
Jaume Pinsach ◽  
Jaume Puig-Bargués ◽  
...  
Keyword(s):  
Soil Water ◽  
Drip Irrigation ◽  
Water Extraction ◽  
Water Dynamics ◽  
Irrigation Frequency ◽  
Deep Drainage ◽  
Water Balance Components ◽  
Water Losses ◽  
Promising Alternative ◽  
Subsurface Drip

Water saving techniques such as drip irrigation are important for rice (Oriza sativa L.) production in some areas. Subsurface drip irrigation (SDI) is a promising alternative for intensive cropping since surface drip irrigation (DI) requires a higher degree of labor to allow the use of machinery. However, the semi-aquatic nature of rice plants and their shallow root system could pose some limitations. A major design issue when using SDI is to select the dripline depth to create appropriate root wetting patterns as well as to reduce water losses by deep drainage and evaporation. Soil texture can greatly affect soil water dynamics and, consequently, optimal dripline depth and irrigation frequency needs. Since water balance components as deep percolation are difficult to estimate under field conditions, soil water models as HYDRUS-2D can be used for this purpose. In the present study, we performed a field experiment using SDI for rice production with Onice variety. Simulations using HYDRUS-2D software successfully validated soil water distribution and, therefore, were used to predict soil water contents, deep drainage, and plant water extraction for two different dripline depths, three soil textures, and three irrigation frequencies. Results of the simulations show that dripline depth of 0.15 m combined with one or two daily irrigation events maximized water extraction and reduced percolation. Moreover, simulations with HYDRUS-2D could be useful to determine the most appropriate location of soil water probes to efficiently manage the SDI in rice.

Sign in / Sign up

Export Citation Format

Share Document