Theoretical study on the application of isothermal compression technology in vapor‐compression refrigeration systems with an isothermal piston

2021 ◽  
Author(s):  
Yu Hu ◽  
Weiqing Xu ◽  
Teng Ren ◽  
Maolin Cai ◽  
Bo Yang ◽  
...  
Keyword(s):  
Theoretical Study ◽  
Vapor Compression ◽  
Isothermal Compression ◽  
Vapor Compression Refrigeration

scholarly journals Review of Multi-Physics Modeling on the Active Magnetic Regenerative Refrigeration

2021 ◽  
Vol 26 (2) ◽  
pp. 47
Author(s):  
Julien Eustache ◽  
Antony Plait ◽  
Frédéric Dubas ◽  
Raynal Glises
Keyword(s):  
Magnetic Field ◽  
Low Temperatures ◽  
Room Temperature ◽  
State Of The Art ◽  
Vapor Compression ◽  
Crucial Step ◽  
Potential Alternative ◽  
Vapor Compression Refrigeration ◽  
Preliminary Study ◽  
Physics Modeling

Compared to conventional vapor-compression refrigeration systems, magnetic refrigeration is a promising and potential alternative technology. The magnetocaloric effect (MCE) is used to produce heat and cold sources through a magnetocaloric material (MCM). The material is submitted to a magnetic field with active magnetic regenerative refrigeration (AMRR) cycles. Initially, this effect was widely used for cryogenic applications to achieve very low temperatures. However, this technology must be improved to replace vapor-compression devices operating around room temperature. Therefore, over the last 30 years, a lot of studies have been done to obtain more efficient devices. Thus, the modeling is a crucial step to perform a preliminary study and optimization. In this paper, after a large introduction on MCE research, a state-of-the-art of multi-physics modeling on the AMRR cycle modeling is made. To end this paper, a suggestion of innovative and advanced modeling solutions to study magnetocaloric regenerator is described.

scholarly journals New HFC/HFO Blends as Refrigerants for the Vapor-Compression Refrigeration System (VCRS)

Energies ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 946
Author(s):  
Bartosz Gil ◽  
Anna Szczepanowska ◽  
Sabina Rosiek
Keyword(s):  
Global Warming ◽  
Global Warming Potential ◽  
Mass Fraction ◽  
Vapor Compression ◽  
Refrigeration System ◽  
Operational Parameters ◽  
Vapor Compression Refrigeration ◽  
Low Global Warming Potential ◽  
Triangular Design

In this work, which is related to the current European Parliament Regulation on restrictions affecting refrigeration, four new three-component refrigerants have been proposed; all were created using low Global Warming Potential(GWP) synthetic and natural refrigerants. The considered mixtures consisted of R32, R41, R161, R152a, R1234ze (E), R1234yf, R1243zf, and RE170. These mixtures were theoretically tested with a 10% step in mass fraction using a triangular design. The analysis covered two theoretical cooling cycles at evaporating temperatures of 0 and −30 °C, and a 30 °C constant condensing temperature. The final stage of the work was the determination of the best mixture compositions by thermodynamic and operational parameters. R1234yf–R152a–RE170 with a weight share of 0.1/0.5/0.4 was determined to be the optimal mixture for potentially replacing the existing refrigerants.

scholarly journals Two-Stage Evaporative Inlet Air Gas Turbine Cooling

Energies ◽  
2021 ◽  
Vol 14 (5) ◽  
pp. 1382
Author(s):  
Obida Zeitoun
Keyword(s):  
Gas Turbine ◽  
Gas Turbines ◽  
Evaporative Cooling ◽  
Air Cooling ◽  
Vapor Compression ◽  
Two Stage ◽  
Turbine Cooling ◽  
Riyadh City ◽  
Vapor Compression Refrigeration ◽  
Gas Turbine Cooling

Gas turbine inlet air-cooling (TIAC) is an established technology for augmenting gas turbine output and efficiency, especially in hot regions. TIAC using evaporative cooling is suitable for hot, dry regions; however, the cooling is limited by the ambient wet-bulb temperature. This study investigates two-stage evaporative TIAC under the harsh weather of Riyadh city. The two-stage evaporative TIAC system consists of indirect and direct evaporative stages. In the indirect stage, air is precooled using water cooled in a cooling tower. In the direct stage, adiabatic saturation cools the air. This investigation was conducted for the GE 7001EA gas turbine model. Thermoflex software was used to simulate the GE 7001EA gas turbine using different TIAC systems including evaporative, two-stage evaporative, hybrid absorption refrigeration evaporative and hybrid vapor-compression refrigeration evaporative cooling systems. Comparisons of different performance parameters of gas turbines were conducted. The added annual profit and payback period were estimated for different TIAC systems.

Sign in / Sign up

Export Citation Format

Share Document