Evaluation of code torsional provisions by a time history approach

1987 ◽  
Vol 15 (4) ◽  
pp. 491-516 ◽  
Author(s):  
A. M. Chandler ◽  
G. L. Hutchinson
Keyword(s):  
Time History ◽  
History Approach

Performance-Based Design Approach for Seismic Rehabilitation of Buildings with Displacement-Dependent Dissipators

2001 ◽  
Vol 17 (3) ◽  
pp. 531-548 ◽  
Author(s):  
Sonia E. Ruiz ◽  
Hiram Badillo
Keyword(s):  
Time History ◽  
Seismic Intensity ◽  
Seismic Retrofitting ◽  
Performance Based Design ◽  
Preliminary Design ◽  
Single Degree Of Freedom ◽  
Ductility Demand ◽  
Seismic Rehabilitation ◽  
Structural Responses ◽  
History Approach

A performance-based approach for seismic retrofitting of buildings with energy dissipating devices is presented. The approach may be seen as an algorithm useful for converging to a preliminary design of a system to be analyzed according to the time history approach recommended in the NEHRP Guidelines for the Seismic Rehabilitation of Buildings (FEMA 273). The algorithm is based on the analysis of equivalent single-degree-of-freedom models with added parallel elements that represent the dissipating devices. The combined systems are analyzed under sets of accelerograms associated with different return intervals. The acceptance criteria are intended to control the peak drift of the rehabilitated structure and the maximum ductility demand of the dissipating devices. It is required that these maximum structural responses, for a given seismic intensity, be equal to or smaller than those associated with a given probability of exceedance. The approach is successfully applied to a ten-story, three-bay frame rehabilitated with U-shaped steel dissipators.

PERILAKU STRUKTUR BAJA TIPE MRF DENGAN BEBAN LATERAL BERDASARKAN SNI 1726-2012 DAN METODE PERFORMANCE BASED PLASTIC DESIGN (PBPD)

2014 ◽  
Vol 13 (1) ◽  
Author(s):  
Nidiasari Jati Sunaryati Eem Ikhsan
Keyword(s):  
Pushover Analysis ◽  
Time History ◽  
Time History Analysis ◽  
Plastic Design ◽  
History Analysis ◽  
Non Linear ◽  
Static Pushover Analysis

Struktur rangka baja pemikul momen merupakan jenis struktur baja tahan gempa yang populer digunakan. Daktilitas struktur yang tinggi merupakan salah satu keunggulan struktur ini, sehingga mampu menahan deformasi inelastik yang besar. Dalam desain, penggunaan metode desain elastis berupa evaluasi non-linear static (Pushover analysis) maupun evaluasi non-linear analisis (Time History Analysis) masih digunakan sebagai dasar perencanaan meskipun perilaku struktur sebenarnya saat kondisi inelastik tidak dapat digambarkan dengan baik. Metode Performance-Based Plastic Design (PBPD) berkembang untuk melihat perilaku struktur sebenarnya dengan cara menetapkan terlebih dahulu simpangan dan mekanisme leleh struktur sehingga gaya geser dasar yang digunakan adalah sama dengan usaha yang dibutuhkan untuk mendorong struktur hingga tercapai simpangan yang telah direncanakan. Studi dilakukan terhadap struktur baja 5 lantai yang diberi beban gempa berdasarkan SNI 1726, 2012 dan berdasarkan metode PBPD. Hasil analisa menunjukkan bahwa struktur yang diberi gaya gempa berdasarkan metode PBPD mencapai simpangan maksimum sesuai simpangan rencana dan kinerja struktur yang dihasilkan lebih baik .

Comparison of Interstorey Drift in General RC Buildings in Pounding and No Pounding Case

2020 ◽  
Vol 2 (1) ◽  
pp. 40-47
Author(s):  
Anand Dev Bhatt
Keyword(s):  
Seismic Analysis ◽  
Linear Time ◽  
Time History ◽  
Case Analysis ◽  
Rc Buildings ◽  
Adjacent Buildings ◽  
Sufficient Distance ◽  
Earthquake Load ◽  
Interstorey Drift ◽  
Lower Height

 Inter-storey drift is an important parameter of structural behavior in seismic analysis of buildings. Pounding effect in building simply means collision between adjacent buildings due to earthquake load caused by out of phase vibration of adjacent buildings. There is variation in inter-storey drift of adjacent buildings during pounding case and no pounding case. The main objective of this research was to compare the inter-storey drift of general adjacent RC buildings in pounding and no pounding case. For this study two adjacent RC buildings having same number of stories have been considered. For pounding case analysis there is no gap in between adjacent buildings and for no pounding case analysis there is sufficient distance between adjacent buildings. The model consists of adjacent buildings having 4 and 4 stories but unequal storey height. Both the buildings have same material & sectional properties. Fast non-linear time history analysis was performed by using El-centro earthquake data as ground motion. Adjacent buildings having different overall height were modelled in SAP 2000 v 15 using gap element for pounding case. Finally, analysis was done and inter-storey drift was compared. It was found that in higher building inter-storey drift is greater in no pounding case than in pounding case but in adjacent lower height building the result was reversed. Additionally, it was found that in general residential RC buildings maximum inter-storey drift occurs in 2nd floor.

PROGRAM OF PREDICTION AND MANAGEMENT OF COINTEGED DYNAMIC ECONOMIC PROCESSES BASED ON THE CYBERNETIC APPROACH

2019 ◽  
Author(s):  
Olena Bundak ◽  
Nataliia Zubovetska
Keyword(s):  
Computer Program ◽  
Pair Correlation ◽  
Time History ◽  
Critical Area ◽  
Concrete Object ◽  
Graphic Arts ◽  
Ex Post ◽  
History Of ◽  
Successive Change ◽  
Rms Errors

A method and computer program ConRow, which prognostication of development of the dynamically CPLD economic transients is executed by, is described in the article. Such prognostication of economic processes is very important in the cases when their development can result in undesirable consequences, that to go out in the so-called critical area. Extrapolation in a critical area with the use of information about the conduct of the system at an area, near to it, allows to estimate to the lead through of experiment in the critical area of his consequence. For the imitation of conduct of object the function of review is set on entrance influence. For a concrete object this function can express, for example, dependence of change of level sale from time-history of charges on advertising and set as a numeral row. Statistics as a result of analysis of row are represented in a table, where the level of meaningfulness is set statistician, and also parameters of the handed over criteria. The graphic reflection of information is intended for visualization of analysis. Here represented on the points of graphic arts, the crooked smoothing which are calculated as полиномиальные regressions is added. The best approaching is controlled by sight on the proper graph, and also by minimization of their rms errors. Models of prognostication by sight and as formulas represented on graphic arts, the middle is here determined tailings and their chance is checked up on statistics of signs. After the got models determined also and prognosis values of influences and reviews. Establishing an order models of Сr(p) of co integrate regression is carried out separate custom controls. The coefficient of clay correlation of ruФ shows by itself pair correlation between lines with a successive change in relation to each other on a size to лагу of l = 1, 2, 3 . The program was tested on the example of ex-post prognosis at establishing an integration connection and possibility of prognostication of growth of nominal average monthly settlings on the basis of these statistical indexes of consumer inflation in Ukraine.

Study on Rational Ratios of Lateral Stiffness for Masonry Building with Frame Structure at First Two Stories

2012 ◽  
Vol 174-177 ◽  
pp. 2012-2015
Author(s):  
Xiao Long Zhou ◽  
Ying Min Li ◽  
Lin Bo Song ◽  
Qian Tan
Keyword(s):  
Seismic Performance ◽  
Time History ◽  
Shear Wall ◽  
Calculation Model ◽  
Frame Structure ◽  
Wall Structure ◽  
Masonry Building ◽  
Lateral Stiffness ◽  
Stiffness Ratio ◽  
Lateral Stiffness Ratio

There are two typical seismic damage characteristics to the masonry building with frame shear wall structure at first two stories, and the lateral stiffness ratio of the third storey to the second storey is one of the key factors mostly affecting the seismic performance of this kind of building. However, some factors are not considered sufficiently in current Chinese seismic codes. According to the theory of performance-based seismic design, the seismic performance of this kind of structure is analyzed in this paper by taking time-history analysis on models which with different storey stiffness ratios. The results show that when the lateral stiffness ratio controlled in a reasonable range, the upper masonry deformation can be ensured in a range of elastic roughly, and the bottom frame can be guaranteed to have sufficient deformation and energy dissipation capacity. Finally, according to the seismic performance characteristics of masonry building with frame shear wall structure at first two stories, especially the characteristics under strong earthquakes, a method of simplified calculation model for the upper masonry is discussed in this paper.

Sign in / Sign up

Export Citation Format

Share Document