scholarly journals Influence of boundary conditions on the out-of-plane response of brick masonry walls in buildings with RC slabs

2016 ◽  
Vol 45 (8) ◽  
pp. 1337-1356 ◽  
Author(s):  
Marco Tondelli ◽  
Katrin Beyer ◽  
Matthew DeJong
Keyword(s):  
Boundary Conditions ◽  
Brick Masonry ◽  
Masonry Walls ◽  
Out Of Plane ◽  
Rc Slabs

scholarly journals Out-of-plane behavior of clay brick masonry walls retrofitted with flexible deep mounted CFRP strips

2021 ◽  
Vol 228 ◽  
pp. 111448
Author(s):  
Ö.S. Türkmen ◽  
S.N.M. Wijte ◽  
B.T. De Vries ◽  
J.M. Ingham
Keyword(s):  
Brick Masonry ◽  
Masonry Walls ◽  
Clay Brick ◽  
Out Of Plane

Experimental Investigation on the Flexural Performance of Brick Masonry Wall Retrofitted Using PP-Band Meshes under Cyclic Loading

2016 ◽  
Vol 845 ◽  
pp. 175-180 ◽  
Author(s):  
Andreas Triwiyono ◽  
Frederica Neo ◽  
Johan Ardianto ◽  
Gumbert Maylda Pratama ◽  
Andreas Sugijopranoto
Keyword(s):  
Cyclic Loading ◽  
Large Deformation ◽  
Masonry Wall ◽  
Brick Masonry ◽  
Structural Performance ◽  
Masonry Walls ◽  
Flexural Performance ◽  
Out Of Plane ◽  
Actual Field ◽  
Optimum Solution

Numbers of residential houses were damaged in some areas caused by earthquakes. The damages greatly affected the number of losses. Most of the houses in some countries are made of brick unreinforced masonry (URM) walls. Improving the structural performance of this kind of masonry has become important. For this reason, experimental study was conducted on the flexural performance of brick walls retrofitted with strapping band (polypropylene/pp-band). The walls were constructed using bricks produced manually with joint mortar ratio of 1 PC: 6 sand, that chosen to represent the actual field conditions of the communities in Indonesia. The aims of the study were to determine the out of plane flexural performance of the non-retrofitted and retrofitted brick masonry walls under cyclic loading by using some variations of the distance between pp-band. The walls were loaded to produce flexural bending that caused vertical and horizontal cracks. The results of the test showed that the retrofitted walls failed by large deformation. After crack, the strength reduced to about 25-50% of the crack load and then regained progressively as residual strength until 150% higher than the strength at crack load by large deformation due to the strapping band mesh. The wall with 10 cm pp-band distance should be used as optimum solution for retrofitting

Sign in / Sign up

Export Citation Format

Share Document