Performance evaluation of selected Transmission Control Protocol variants over a digital video broadcasting-second generation broadband satellite multimedia system with QoS

2012 ◽  
Vol 26 (12) ◽  
pp. 1579-1598 ◽  
Author(s):  
Elizabeth Rendon-Morales ◽  
Jorge Mata-Díaz ◽  
Juanjo Alins ◽  
Jose L. Muñoz ◽  
Oscar Esparza
Keyword(s):  
Performance Evaluation ◽  
Digital Video ◽  
Second Generation ◽  
Transmission Control Protocol ◽  
Multimedia System ◽  
Transmission Control ◽  
Digital Video Broadcasting ◽  
Video Broadcasting ◽  
Control Protocol

scholarly journals DVB-T2: The Second Generation of Terrestrial Digital Video Broadcasting System

2014 ◽  
Vol 60 (2) ◽  
pp. 258-271 ◽  
Author(s):  
Inaki Eizmendi ◽  
Manuel Velez ◽  
David Gomez-Barquero ◽  
Javier Morgade ◽  
Vicente Baena-Lecuyer ◽  
...  
Keyword(s):  
Digital Video ◽  
Second Generation ◽  
Digital Video Broadcasting ◽  
Video Broadcasting ◽  
Broadcasting System

scholarly journals CNR and BER Ranges for the DVB-T2 Reception-Success

2017 ◽  
Vol 7 (6) ◽  
pp. 3727 ◽  
Author(s):  
Budi Setiyanto ◽  
Risanuri Hidayat ◽  
I Wayan Mustika ◽  
Sunarno Sunarno
Keyword(s):  
Bit Error Rate ◽  
Error Rate ◽  
Digital Video ◽  
Second Generation ◽  
Field Measurements ◽  
Real Data ◽  
Digital Video Broadcasting ◽  
Numerical Examples ◽  
Video Broadcasting

DVB-T2 (Digital Video Broadcasting Terrestrial Second Generation) reception requires a sufficient quality of the received signal. <em>CNR</em> (carrier-to-noise ratio) and <em>BER</em> (bit-error-rate) are two of quantities describing the quality. This paper presents the range of each quantity providing a successful reception based on real data obtained by field-measurements. This data was collected from MO (mobile-outdoor) and SI (stationary-indoor) receiving-systems capturing signal sent by some on-air trial transmitters broadcasting services focused on the fixed-receivers. The result indicated that the successful and failed receptions were split into two quite separated (concentrated) ranges of post-decoded <em>BER</em> and therefore a boundary distinguishing them could be prominently defined. In contrast, they were spread in a wide common range of <em>CNR</em> and pre-decoded <em>BER</em>. Furthermore, the boundary that corresponded to this last quantity was ambiguous. In the case of MO reception as numerical examples, the two split ranges of post-decoded <em>BER</em> were less than about 10<sup>-5</sup> and more than about 2.7 × 10<sup>-4</sup> for the successful and failed receptions, respectively, whereas <em>CNR</em> as high as about 14 dB could be viewed as a soft boundary distinguishing these both reception-success conditions.

scholarly journals Raised Cosine Filter Implementation on Digital Video Broadcasting Satellite 2 (DVB-S2)

2021 ◽  
Vol 5 (6) ◽  
pp. 1018-1024
Author(s):  
Rio Setiawan ◽  
Emy Haryatmi
Keyword(s):  
Digital Video ◽  
Second Generation ◽  
Noisy Channel ◽  
Digital Video Broadcasting ◽  
Matlab Simulink ◽  
Video Broadcasting

The development of digital video broadcasting is still continue recently and was done by many parties. One of the project regarding this research was DVB project. There was three areas in digital video broadcasting. One of them was Digital Video Broadcasting Satellite Second Generation (DVB-S2). The development of this project is not focus only in video broadcasting but also focus in applications and mutlimedia services. The objective of this research was to implement raised cosine filter in DVB-S2 using matlab simulink in order to optimize SNR and BER value. Parameters used in this project was QPSK mode and LDPC with 50 iteration. Those parameters was chosen to maintain originality of data that sent in noisy channel. The result showed that by implementing raised cosine filter could optimized BER value of the system. The higher SNR value would give the lower BER value. In static video, the best SNR value when using a filter is 0.9 dB with a BER value of 0.000004810 while for dynamic video the SNR is 0.9 with a BER value of 0.00001030.  

Frame Synchronization for DVB-S2 in Physical Layer Header Code Uncertainty

2014 ◽  
Vol 543-547 ◽  
pp. 2632-2635
Author(s):  
Hao Wu ◽  
Hui Xie ◽  
Zhi Tao Huang ◽  
Yi Yu Zhou
Keyword(s):  
Digital Video ◽  
Second Generation ◽  
Physical Layer ◽  
Differential Detection ◽  
Frame Synchronization ◽  
Digital Video Broadcasting ◽  
Video Broadcasting ◽  
Integration Techniques

The first challenging step of the demodulation of the Digital Video Broadcasting Second generation signal is frame synchronization. Physical Layer header is composed of Start of Frame and Physical Layer Signalling code. When the Start of Frame and the structure of Physical Layer Signalling code are known, Choi and Lee, Kim et al denote some Choi Lee Detectors and Post Detection Integration techniques, using the combination of differential detection of header code. In this paper, we present a scheme to achieve frame synchronization on the condition that the Physical Layer header code is uncertain.

Simplified Rotated Constellation Demapper for Second Generation Terrestrial Digital Video Broadcasting

2013 ◽  
Vol 59 (1) ◽  
pp. 160-167 ◽  
Author(s):  
D. Perez-Calderon ◽  
V. Baena-Lecuyer ◽  
A. C. Oria ◽  
P. Lopez ◽  
J. G. Doblado
Keyword(s):  
Digital Video ◽  
Second Generation ◽  
Digital Video Broadcasting ◽  
Video Broadcasting
Sign in / Sign up

Export Citation Format

Share Document