An Efficient Photocatalyst Based on Black TiO 2 Nanoparticles and Porous Carbon with High Surface Area: Degradation of Antibiotics and Organic Pollutants in Water

ChemPlusChem ◽  
2019 ◽  
Vol 84 (5) ◽  
pp. 474-480 ◽  
Author(s):  
Yu Fang ◽  
Yuanyuan Li ◽  
Feng Zhou ◽  
Peiyang Gu ◽  
Jiadi Liu ◽  
...  
Keyword(s):  
Surface Area ◽  
Organic Pollutants ◽  
Porous Carbon ◽  
High Surface ◽  
High Surface Area

scholarly journals Highly Porous Carbon Materials from Biomass by Chemical and Carbonization Method: A Comparison Study

2013 ◽  
Vol 2013 ◽  
pp. 1-6 ◽  
Author(s):  
Wan Nor Roslam Wan Isahak ◽  
Mohamed Wahab Mahamed Hisham ◽  
Mohd Ambar Yarmo
Keyword(s):  
Sulfuric Acid ◽  
Thermal Behavior ◽  
Surface Area ◽  
Porous Carbon ◽  
High Surface ◽  
High Surface Area ◽  
Empty Fruit Bunches ◽  
Heating Treatment ◽  
Concentrated Sulfuric Acid ◽  
Highly Porous

Porous carbon obtained by dehydrating agent, concentrated sulfuric acid (H2SO4), from biomass containing high cellulose (filter paper (FP), bamboo waste, and empty fruit bunches (EFB)) shows very high surface area and better thermal behavior. At room temperature (without heating), treatment of H2SO4removed all the water molecules in the biomass and left the porous carbon without emitting any gaseous byproducts. Brunauer-Emmett-Teller (BET) surface analysis has shown that bamboo-based carbon has good properties with higher surface area (507.8 m2/g), micropore area (393.3 m2/g), and better thermal behavior (compared to FP and EFB) without any activation or treatment process. By acid treatment of biomass, it was shown that higher carbon composition obtained from FP (85.30%), bamboo (77.72%), and EFB (76.55%) is compared to carbon from carbonization process. Under optimal sulfuric acid (20 wt.%) uses, high carbon yield has been achieved for FP (47.85 wt.%), bamboo (62.4 wt.%), and EFB (55.4 wt.%).

Preparing high surface area porous carbon from biomass by carbonization in a molten salt medium

RSC Advances ◽  
2015 ◽  
Vol 5 (92) ◽  
pp. 75728-75734 ◽  
Author(s):  
Huishan Shang ◽  
Yanjie Lu ◽  
Feng Zhao ◽  
Cong Chao ◽  
Bing Zhang ◽  
...  
Keyword(s):  
Molten Salt ◽  
Surface Area ◽  
Porous Carbon ◽  
High Surface ◽  
High Surface Area ◽  
Molten Salt Synthesis ◽  
Synthesis Process ◽  
Salt Medium ◽  
Peanut Shells

Peanut shells were transformed into porous carbon with a high surface area through a simple ZnCl2-molten salt synthesis process.

scholarly journals Dopamine Assisted One-Step Pyrolysis of Glucose for the Preparation of Porous Carbon with A High Surface Area

Nanomaterials ◽  
2018 ◽  
Vol 8 (10) ◽  
pp. 854 ◽  
Author(s):  
Hanbo Xiao ◽  
Cheng-an Tao ◽  
Yujiao Li ◽  
Xianzhe Chen ◽  
Jian Huang ◽  
...  
Keyword(s):  
Surface Area ◽  
Porous Carbon ◽  
Carbon Materials ◽  
High Current Density ◽  
High Surface ◽  
High Surface Area ◽  
Energy Storage Materials ◽  
One Pot ◽  
Component Structure ◽  
Porous Carbon Materials

Herein, a facile dopamine assisted one-pot synthesis approach is proposed for the preparation of porous carbon with a specific surface area (SSA) up to 2593 m2/g through the direct pyrolysis of a mixture of glucose, NH4Cl, and dopamine hydrochloride (DAH). The glucose is adopted as the carbon source and foaming agent, NH4Cl is used as the blowing agent, and DAH is served as collaborative carbon precursor as well as the nitrogen source for the first time. The effect of dopamine on the component, structure, and SSA of the as-prepared porous carbon materials are systematically studied. The moderate addition of dopamine, which influences the condensation and polymerization of glucose, matches better with ammonium salt decomposition. The SSA of porous carbon increases first and then decreases with the increasing amount of dopamine. In our case, the porous carbon produced with 5 wt% dopamine (PC-5) achieves the maximum SSA of up to 2593 m2/g. Accordingly, it also shows the greatest electrochemical performance. The PC-5 shows a capacitance of 96.7 F/g calculated from the discharge curve at 1 A/g. It also has a good capacitive rate capacity, the specific capacitance can still maintain 80%, even at a high current density of 10 A/g. Moreover, PC-5 exhibits a good cycling stability of 98.1% capacitive retention after 1000 cycles. The proposed method may show promising prospects for preparing porous carbon materials as advanced energy storage materials, storage, and catalyst supports.

Rich N/O/S co-doped porous carbon with a high surface area from silkworm cocoons for superior supercapacitors

2019 ◽  
Vol 43 (48) ◽  
pp. 19372-19378 ◽  
Author(s):  
Jianyu Huang ◽  
Simin Liu ◽  
Zifang Peng ◽  
Zhuoxian Shao ◽  
Yuanyuan Zhang ◽  
...  
Keyword(s):  
Surface Area ◽  
Porous Carbon ◽  
Electrode Materials ◽  
Synergistic Effects ◽  
High Surface ◽  
High Surface Area ◽  
Porous Carbons ◽  
Co Doped

The synergistic effects of high surface area and abundant heteroatoms make porous carbons superior electrode materials.

scholarly journals Sorghum-Waste-Derived High-Surface Area KOH-Activated Porous Carbon for Highly Efficient Methylene Blue and Pb(II) Removal

ACS Omega ◽  
2020 ◽  
Vol 5 (23) ◽  
pp. 13548-13556 ◽  
Author(s):  
Junhua Hou ◽  
Yijian Liu ◽  
Shikai Wen ◽  
Weitao Li ◽  
Riquan Liao ◽  
...  
Keyword(s):  
Methylene Blue ◽  
Surface Area ◽  
Porous Carbon ◽  
High Surface ◽  
High Surface Area ◽  
Highly Efficient

scholarly journals High surface-area carbon microcantilevers

2019 ◽  
Vol 1 (3) ◽  
pp. 1148-1154 ◽  
Author(s):  
Steven G. Noyce ◽  
Richard R. Vanfleet ◽  
Harold G. Craighead ◽  
Robert C. Davis
Keyword(s):  
Surface Area ◽  
Porous Carbon ◽  
High Surface ◽  
High Surface Area ◽  
Sensitive Detection

Fully-porous carbon resonators were formed with precise microscale dimension and characterized for sensitive detection of vapors.

Cellulose generated-microporous carbon nanosheets with nitrogen doping

RSC Advances ◽  
2014 ◽  
Vol 4 (18) ◽  
pp. 9126-9132 ◽  
Author(s):  
Wenzhong Shen ◽  
Tuoping Hu ◽  
Weibin Fan
Keyword(s):  
Surface Area ◽  
Porous Carbon ◽  
Pore Volume ◽  
Nitrogen Doping ◽  
High Surface ◽  
High Surface Area ◽  
Structural Features ◽  
Carbon Nanosheets ◽  
Nitrogen Doped ◽  
Adsorption Performance

Nanosheet porous carbon with high surface area and pore volume, unique compositional and structural features endow the nitrogen-doped porous carbon nanosheets with superior CO2 adsorption performance.

Sign in / Sign up

Export Citation Format

Share Document