ChemInform Abstract: Matrix Effects in the Reactions of Organic Radical Cations in Ground and Excited States in Solid Phase

ChemInform ◽  
2000 ◽  
Vol 31 (49) ◽  
pp. no-no
Author(s):  
V. I. Fel'dman ◽  
M. Ya. Mel'nikov
Keyword(s):  
Excited States ◽  
Matrix Effects ◽  
Solid Phase ◽  
Radical Cations ◽  
Organic Radical

Bioanalytical method development and validation of simultaneous analysis of telmisartan and hydrochlorthiazide in human plasma using LC-MS/MS

2016 ◽  
Vol 5 (03) ◽  
pp. 4862 ◽  
Author(s):  
Mathew George* ◽  
Lincy Joseph ◽  
Arpit Kumar Jain ◽  
Anju V.
Keyword(s):  
Human Plasma ◽  
Retention Time ◽  
High Performance ◽  
Method Development ◽  
Matrix Effects ◽  
Solid Phase ◽  
Internal Standard ◽  
Assay Method ◽  
Buffer System ◽  
Internal Standards

A simple, sensitive, rapid and economic high performance thin layer chromatographic method and a mass spectroscopic assay method has been developed for the quantification of telmisartan and hydrochlorthiazide combination in human plasma. The internal standards and analytes were extracted from human plasma by solid-phase extraction with HLB Oasis1cc (30mg) catridges. The scanning and optimization for the samples are done using methanol: water (50:50). The samples were chromatographed using reverse phase chromatography with C-18 column of different manufacturers like Ascentis C18 (150×4. 6, 5µ) using the buffer system Acetonitrile: Buffer (80:20%v/v) which consist of 2±0. 1Mm ammonium format at a flow rate of 0. 7ml/min at a column oven temperature 35±10c. The internal standard used was hydrochlorthiazide13c1, d2 and telmisartand3. The extraction techniques include conditioning, loading, washing and elution, drying followed by reconstitution of the dried samples. The volume injected was 10µl with the retention time of 3-4 min for telmisartan, 1-2 min for hydrochlorthiazide and for the internal standards the retention time was 3-4 min for telmisartand3 and 1-2 min for hydrochlorthiazide c13d2. The rinsing solution was Acetonitrile: HPLC grade water in the ratio (50:50). The above developed method was validated using various parameters like selectivity and sensitivity, accuracy and precision, matrix effects, % recovery and various stability studies. The method was proved to be sensitive, accurate, precise and reproducible. The preparation showed high recovery for the quantitative determination of telmisartan and hydrochlorthiazide in human plasma.

A solid-phase extraction method that eliminates matrix effects of complex pulp mill effluents for the analysis of lipophilic wood extractives

2020 ◽  
Vol 35 (4) ◽  
pp. 577-588
Author(s):  
Sebastian España Orozco ◽  
Philipp Zeitlinger ◽  
Karin Fackler ◽  
Robert H. Bischof ◽  
Antje Potthast
Keyword(s):  
Solid Phase Extraction ◽  
Matrix Effects ◽  
Solid Phase ◽  
Internal Standard ◽  
Pulp Mill ◽  
Phase Extraction ◽  
Wood Extractives ◽  
Wood Extractive ◽  
Pulp Mill Effluents ◽  
The Impact

AbstractThe extraction of lipophilic wood extractives from pulp and paper process waters proves to be a challenging task, due to harsh and alternating process and sample conditions. This study has determined the potential use of polymeric sorbents for solid-phase extraction (SPE) and compared to classical silica-based reversed-phase packed columns, with polymeric hydrophilic-lipophilic balanced (HLB) cartridges being the sorbent with the most potential. Recovery functions were obtained with an internal standard mixture representative for the main lipophilic wood extractive groups, which are fatty acids and alcohols, sterols, sterol esters and triglycerides. The impact of pH, sample volume and sample matrix, expressed as TOC and cations, on the retention behavior of lipophilic extractives during SPE of industrial samples were determined with polymeric HLB sorbent. High variations in the composition of pulp mill matrices led to different optimal extraction conditions. Thus, a new SPE protocol was developed, which bypasses matrix interferences and omits the loss of analytes due to sample preparation. The method is applicable to different pulp mill effluents with large discrepancies in pH and sample matrices, resulting in recoveries >90 % with RSD <5 % for all lipophilic wood extractives.

scholarly journals Sample Preparation and Extraction in Small Sample Volumes Suitable for Pediatric Clinical Studies: Challenges, Advances, and Experiences of a Bioanalytical HPLC-MS/MS Method Validation Using Enalapril and Enalaprilat

2015 ◽  
Vol 2015 ◽  
pp. 1-11 ◽  
Author(s):  
Bjoern B. Burckhardt ◽  
Stephanie Laeer
Keyword(s):  
Sample Preparation ◽  
Solid Phase Extraction ◽  
Method Development ◽  
Matrix Effects ◽  
Solid Phase ◽  
Scale Up ◽  
Small Sample ◽  
Positive Pressure ◽  
Phase Extraction ◽  
Bioanalytical Method

In USA and Europe, medicines agencies force the development of child-appropriate medications and intend to increase the availability of information on the pediatric use. This asks for bioanalytical methods which are able to deal with small sample volumes as the trial-related blood lost is very restricted in children. Broadly used HPLC-MS/MS, being able to cope with small volumes, is susceptible to matrix effects. The latter restrains the precise drug quantification through, for example, causing signal suppression. Sophisticated sample preparation and purification utilizing solid-phase extraction was applied to reduce and control matrix effects. A scale-up from vacuum manifold to positive pressure manifold was conducted to meet the demands of high-throughput within a clinical setting. Faced challenges, advances, and experiences in solid-phase extraction are exemplarily presented on the basis of the bioanalytical method development and validation of low-volume samples (50 μL serum). Enalapril, enalaprilat, and benazepril served as sample drugs. The applied sample preparation and extraction successfully reduced the absolute and relative matrix effect to comply with international guidelines. Recoveries ranged from 77 to 104% for enalapril and from 93 to 118% for enalaprilat. The bioanalytical method comprising sample extraction by solid-phase extraction was fully validated according to FDA and EMA bioanalytical guidelines and was used in a Phase I study in 24 volunteers.

scholarly journals Cannabinoids in Exhaled Breath following Controlled Administration of Smoked Cannabis

2013 ◽  
Vol 59 (12) ◽  
pp. 1780-1789 ◽  
Author(s):  
Sarah K Himes ◽  
Karl B Scheidweiler ◽  
Olof Beck ◽  
David A Gorelick ◽  
Nathalie A Desrosiers ◽  
...  
Keyword(s):  
Solid Phase Extraction ◽  
Time Course ◽  
Matrix Effects ◽  
Solid Phase ◽  
Driving Under The Influence ◽  
Phase Extraction ◽  
Exhaled Breath ◽  
C Storage ◽  
Before And After ◽  
Occasional Smoker

BACKGROUND Δ9-Tetrahydrocannabinol (THC), 11-nor-9-carboxy-THC (THCCOOH), and cannabinol (CBN) were measured in breath following controlled cannabis smoking to characterize the time course and windows of detection of breath cannabinoids. METHODS Exhaled breath was collected from chronic (≥4 times per week) and occasional (&lt;twice per week) smokers before and after smoking a 6.8% THC cigarette. Sample analysis included methanol extraction from breath pads, solid-phase extraction, and liquid chromatography–tandem mass spectrometry quantification. RESULTS THC was the major cannabinoid in breath; no sample contained THCCOOH and only 1 contained CBN. Among chronic smokers (n = 13), all breath samples were positive for THC at 0.89 h, 76.9% at 1.38 h, and 53.8% at 2.38 h, and only 1 sample was positive at 4.2 h after smoking. Among occasional smokers (n = 11), 90.9% of breath samples were THC-positive at 0.95 h and 63.6% at 1.49 h. One occasional smoker had no detectable THC. Analyte recovery from breath pads by methanolic extraction was 84.2%–97.4%. Limits of quantification were 50 pg/pad for THC and CBN and 100 pg/pad for THCCOOH. Solid-phase extraction efficiency was 46.6%–52.1% (THC) and 76.3%–83.8% (THCCOOH, CBN). Matrix effects were −34.6% to 12.3%. Cannabinoids fortified onto breath pads were stable (≤18.2% concentration change) for 8 h at room temperature and −20°C storage for 6 months. CONCLUSIONS Breath may offer an alternative matrix for identifying recent driving under the influence of cannabis, but currently sensitivity is limited to a short detection window (0.5–2 h).

Direct emission from quartet excited states triggered by upconversion phenomena in solid-phase synthesized fluorescent lead-free organic–inorganic hybrid compounds

2019 ◽  
Vol 7 (46) ◽  
pp. 26504-26512 ◽  
Author(s):  
Atanu Jana ◽  
Shynggys Zhumagali ◽  
Qiankai Ba ◽  
Arun S. Nissimagoudar ◽  
Kwang S. Kim
Keyword(s):  
Excited States ◽  
Solid Phase ◽  
Lead Free ◽  
Inorganic Hybrid ◽  
Hybrid Compounds ◽  
Direct Emission ◽  
First Time

We report, for the first time, the solid-phase gram-scale synthesis of two lead-free, zero-dimensional (0D) fluorescent organic–inorganic hybrid compounds, [Bu4N]2[MnBr4] (1) and [Ph4P]2[MnBr4] (2).

Isomerization Behavior of Halostilbene Radical Cations in the Excited States. Two-Color Photochemistry of Stilbene Derivatives

1994 ◽  
Vol 23 (8) ◽  
pp. 1371-1374 ◽  
Author(s):  
Yasunao Kuriyama ◽  
Fumiko Hashimoto ◽  
Masahiro Tsuchiya ◽  
Hirochika Sakuragi ◽  
Katsumi Tokumaru
Keyword(s):  
Excited States ◽  
Radical Cations ◽  
Stilbene Derivatives

Matrix effects of milk, dairy factory wastewater and soil water on the determination of disinfection by-products andpara-cresol using solid-phase microextraction

2013 ◽  
Vol 67 (1) ◽  
pp. 55-66 ◽  
Author(s):  
Michael W Heaven ◽  
T Vincent Verheyen ◽  
Alicia Reynolds ◽  
Karl Wild ◽  
Mark Watkins ◽  
...  
Keyword(s):  
Soil Water ◽  
Solid Phase Microextraction ◽  
Matrix Effects ◽  
Solid Phase ◽  
By Products
Sign in / Sign up

Export Citation Format

Share Document