Kinetics of formation of humic substances in activated sludge systems and their effect on flocculation

1974 ◽  
Vol 16 (6) ◽  
pp. 739-755 ◽  
Author(s):  
F. B. DeWalle ◽  
E. S. K Chian
Keyword(s):  
Activated Sludge ◽  
Humic Substances ◽  
Kinetics Of Formation ◽  
Kinetics Of ◽  
Activated Sludge Systems

Processes and Modelling of Nitrification Denitrification Biological Excess Phosphorus Removal Systems – A Review

1992 ◽  
Vol 25 (6) ◽  
pp. 59-82 ◽  
Author(s):  
M. C. Wentzel ◽  
G. A. Ekama ◽  
G. v. R. Marais
Keyword(s):  
Kinetic Model ◽  
Activated Sludge ◽  
Phosphorus Removal ◽  
Model Development ◽  
Constant Flow ◽  
Cyclic Flow ◽  
Aerobic Nitrification ◽  
Kinetics Of ◽  
Load Conditions ◽  
Activated Sludge Systems

This paper reviews developments in modelling the kinetics of activated sludge systems: Completely aerobic nitrification, anoxic/aerobic nitrification denitrification (ND), and anaerobic/anoxic/aerobic nitrification denitrification biological excess phosphorus removal (NDBEPR) systems. The paper highlights the progress in developing a general NDBEPR activated sludge kinetic model – development of polyP organism enhanced cultures, their kinetics, simplification of the kinetics for enhanced cultures under constant flow and load conditions, extension of the simplified model to mixed culture NDBEPR systems under constant flow and load conditions, integration of the polyP organism enhanced culture kinetics with the ND kinetics to give a general NDBEPR kinetic model for cyclic flow and load which incorporates the increased specific denitrification rates observed in NDBEPR systems compared to ND systems. Areas of research that require attention to complete the development of the general NDBEPR kinetic model are identified – denitrification by polyP organisms, calibration and verification of the model for cyclic flow and load, etc.

The Effect of Metallic and Ionic Species on the Performance of a Biological Effluent Treatment System

1977 ◽  
Vol 12 (1) ◽  
pp. 191-212
Author(s):  
B. Volesky ◽  
Q. Samak ◽  
P. Waller
Keyword(s):  
Activated Sludge ◽  
Inorganic Ions ◽  
Industrial Effluents ◽  
Original Data ◽  
Ionic Species ◽  
Threshold Concentration ◽  
Effluent Treatment ◽  
Organic Load ◽  
Metallic Ions ◽  
Activated Sludge Systems

Abstract Review of the available results appearing in the recent literature is presented focusing particularly upon the effects of metallic ions such as Cr, Cu, Zn, Cd, Hg, V, Zn, Ni and Co. Some original data involving the effects of Na are presented and discussed. Development of parameters used in evaluating the influence of toxic or inhibitory species on the mixed microbial population of an activated sludge system is of crucial importance and different techniques employed such as BOD-COD-TOC-removal rates, Oxygen Uptake Rate, and others are discussed, showing relative inadequacy of currently applied assays. From the data available, certain trends can be discerned. There is a definite threshold concentration for each metallic ion, depending on the organic load of the feed. In the order of increasing toxicity to activated sludge systems reflected in lower BOD removals the following metals have been listed as inhibiting factors at concentrations starting from 1 ppm applied on a continuous basis: hexavalent chromium, cobalt, zinc, cadmium, trivalent chromium, copper and nickel. Metals in combination have not been reported to exhibit any significantly different effects as compared to those observed with individually introduced metallic ions. Tolerance of some activated sludge systems to shock loadings by various inorganic ions and metals is reviewed. The conclusions are of particular importance for estimating the performance of biox systems handling industrial effluents which are likely to contain toxic components of inorganic or metallic nature.

On the Problem of “Two-Phase” Activated Sludge

1991 ◽  
Vol 24 (7) ◽  
pp. 59-64 ◽  
Author(s):  
R. W. Szetela
Keyword(s):  
Activated Sludge ◽  
Single Phase ◽  
Phase System ◽  
Two Phase ◽  
Wastewater Treatment Process ◽  
Sludge Stabilization ◽  
Technological Advantage ◽  
In Series ◽  
State Models ◽  
Activated Sludge Systems

Steady-state models are presented to describe the wastewater treatment process in two activated sludge systems. One of these makes use of a single complete-mix reactor; the other one involves two complete-mix reactors arranged in series. The in-series system is equivalent to what is known as the “two-phase” activated sludge, a concept which is now being launched throughout Poland in conjunction with the PROMLECZ technology under implementation. Analysis of the mathematical models has revealed the following: (1) treatment efficiency, excess sludge production, energy consumption, and the degree of sludge stabilization are identical in the two systems; (2) there exists a technological equivalence of “two-phase” sludge with “single-phase” sludge; (3) the “two-phase” system has no technological advantage over the “single-phase” system.

The Use of Anoxic Selectors for the Control of Low F/M Activated Sludge Bulking

1989 ◽  
Vol 21 (6-7) ◽  
pp. 609-619 ◽  
Author(s):  
Y.-J. Shao ◽  
David Jenkins
Keyword(s):  
Organic Matter ◽  
Activated Sludge ◽  
Pilot Plant ◽  
Detention Time ◽  
Substrate Removal ◽  
Batch System ◽  
Sludge Bulking ◽  
N Removal ◽  
Soluble Substrate ◽  
Activated Sludge Systems

Laboratory and pilot plant experiments on anoxic selector activated sludge systems were conducted on two wastewaters in some cases supplemented with nitrate, acetate or glucose. To prevent bulking sufficient anoxic selector detention time and nitrate levels must be available to reduce selector effluent soluble COD to below 100 mg/l and to reduce readily metabolizable organic matter to virtually zero (< 1 mg/l). Soluble COD/NO3-N removal stoichiometry is in the range 6.0-6.7. Selector systems have elevated soluble substrate removal and denitrification rates compared to CSTR systems. These rates are not affected greatly by temperature (20-25°C) for CSTR sludges but are for selector sludges. Upon exhaustion of nitrate in a selector soluble COD leaks out of the activated sludge in significant amounts. Thiothrix sp. and type 021N denitrify only to NO2 and at much slower rates than Zoogloearamigera does to N2. A sequencing batch system provides an optimistic estimate of the SVI that can be obtained by an anoxic selector system.

Quantification of the kinetic differences between communities isolated from completely mixed activated sludge systems operated with or without a selector using a novel respirometric method

1994 ◽  
Vol 30 (11) ◽  
pp. 255-261 ◽  
Author(s):  
Barth F. Smets ◽  
Timothy G. Ellis ◽  
Stephanie Brau ◽  
Richard W. Sanders ◽  
C. P. Leslie Grady
Keyword(s):  
Oxygen Consumption ◽  
Activated Sludge ◽  
Physiological Changes ◽  
Biodegradation Kinetics ◽  
Substrate Removal ◽  
Biomass Yields ◽  
Selection For ◽  
Single Oxygen ◽  
Activated Sludge Systems

This study quantified the kinetic differences in microbial communities isolated from completely mixed activated sludge (CMAS) systems that were operated either with or without an aerobic selector preceding the main reactor. A new respirometric method was employed that allowed the determination of biodegradation kinetics from single oxygen consumption curves, thereby minimizing physiological changes to the examined communities during the assay. Results indicated that increased values for Ks and μmax for acetate, phenol, and 4-chlorophenol degradation were measured in the CMAS system operated with a selector. The biomass yields on acetate, phenol, and 4-chlorophenol were very similar in both systems. These findings indicate that the operation of CMAS systems with aerobic selectors may result in the selection for degrading populations with higher Ks and μmax values for both biogenic and xenobiotic organic compounds, and that substrate storage in the selector only partially contributes to increased substrate removal rates.

Small Activated Sludge Performance and Viability Characteristics under Intermittent and Reduced Flows

1993 ◽  
Vol 28 (10) ◽  
pp. 309-316
Author(s):  
Bilsen Beler Baykal
Keyword(s):  
Activated Sludge ◽  
System Performance ◽  
Treatment Plant ◽  
Generation Model ◽  
Transient States ◽  
Stepwise Manner ◽  
Seasonal Basis ◽  
Soluble Substrate ◽  
House Site ◽  
Activated Sludge Systems

Small activated sludge systems operate in transient states under intermittent and variable flows. Simulations for such a treatment plant in a summer house site operating on a seasonal basis is investigated for system performance and viability using the five component inert soluble substrate generation model. The results have revealed that the viability drops to zero within the first month after the cessation of the feed for intermittently loaded systems that are fed during the summer months, while it never reaches that value for systems operating all year round with reduced flows off season. Restartup is compulsory for the intermittent loadings while the system adapts itself in a stepwise manner for the year round operation. Other factors being comparable, conventional operation with shorter sludge ages may be preferable since viability of the sludge is higher and the effluent COD is comparable.

Sign in / Sign up

Export Citation Format

Share Document