Temperature-dependent pyrolytic product evolution profile for polyethylene terephthalate

2013 ◽  
pp. n/a-n/a ◽  
Author(s):  
Ujwala Hujuri ◽  
Aloke K. Ghoshal ◽  
Sasidhar Gumma
Keyword(s):  
Polyethylene Terephthalate ◽  
Temperature Dependent ◽  
Product Evolution ◽  
Pyrolytic Product

Temperature-dependent pyrolytic product evolution profile for polypropylene

2010 ◽  
Vol 119 (4) ◽  
pp. 2318-2325 ◽  
Author(s):  
Ujwala Hujuri ◽  
Aloke K. Ghoshal ◽  
Sasidhar Gumma
Keyword(s):  
Temperature Dependent ◽  
Product Evolution ◽  
Pyrolytic Product

(111) Monocrystalline Nickel Films

1972 ◽  
Vol 30 ◽  
pp. 512-513
Author(s):  
T.E. Pratt ◽  
R.W. Vook
Keyword(s):  
Film Thickness ◽  
Deposition Rate ◽  
Room Temperature ◽  
Narrow Range ◽  
High Vacuum ◽  
Residual Pressure ◽  
Temperature Dependent ◽  
Deposition Parameters ◽  
Transmission Electron ◽  
Substrate Temperatures

(111) oriented thin monocrystalline Ni films have been prepared by vacuum evaporation and examined by transmission electron microscopy and electron diffraction. In high vacuum, at room temperature, a layer of NaCl was first evaporated onto a freshly air-cleaved muscovite substrate clamped to a copper block with attached heater and thermocouple. Then, at various substrate temperatures, with other parameters held within a narrow range, Ni was evaporated from a tungsten filament. It had been shown previously that similar procedures would yield monocrystalline films of CU, Ag, and Au.For the films examined with respect to temperature dependent effects, typical deposition parameters were: Ni film thickness, 500-800 A; Ni deposition rate, 10 A/sec.; residual pressure, 10-6 torr; NaCl film thickness, 250 A; and NaCl deposition rate, 10 A/sec. Some additional evaporations involved higher deposition rates and lower film thicknesses.Monocrystalline films were obtained with substrate temperatures above 500° C. Below 450° C, the films were polycrystalline with a strong (111) preferred orientation.

Treatment of polyethylene terephthalate in a He glow discharge

2001 ◽  
Vol 11 (PR3) ◽  
pp. Pr3-357-Pr3-362 ◽  
Author(s):  
D. D. Papakonstantinou ◽  
D. Mataras ◽  
Arefi-Khonsari
Keyword(s):  
Glow Discharge ◽  
Polyethylene Terephthalate

In Vitro Effects of Urokinase — Prevention by Different Inhibitors

1990 ◽  
Vol 64 (03) ◽  
pp. 402-406 ◽  
Author(s):  
M D Oethinger ◽  
E Seifried
Keyword(s):  
In Vitro Study ◽  
Thrombin Time ◽  
Plasma Samples ◽  
Temperature Dependent ◽  
Chloromethyl Ketone ◽  
Control Value ◽  
Dose Time ◽  
In Vitro Effects ◽  
Full Protection

SummaryThe present in vitro study investigated dose-, time- and temperature-dependent effects of two-chain urokinase plasminogen activato(u-PA, urokinase) on normal citrated plasma. When 10 μg/ml u-PA wereadded to pooled normal plasma and incubated for 30 min at an ambient temperature (25° C), α2-antiplas-min decreased to 8% of the control value. Incubation on ice yielded a decrease to 45% of control,whereas α2-antiplasmin was fully consumed at 37° C. Fibrinogen and plasminogen fell to 46% and 39%, respectively, after a 30 min incubation at 25° C. Thrombin time prolonged to 190% of control.Various inhibitors were studied with respect to their suitability and efficacy to prevent these in vitro effects. Aprotinin exhibited a good protective effect on fibrinogen at concentrations exceeding 500 KlU/ml plasma. Its use, however, was limited due to interferences with some haemostatic assays. We could demonstrate that L-Glutamyl-L-Glycyl-L-Arginyl chloromethyl ketone (GGACK) and a specific polyclonal anti-u-PA-antibody (anti-u-PA-IgG) effectively inhibited urokinase-induced plasmin generation without interfering with haemostatic assays. The anti-u-PA-antibody afforded full protection ofα2-antiplasmin at therapeutic levels of u-PA.It is concluded that u-PA in plasma samples from patients during thrombolytic therapy may induce in vitro effects which should be prevented by the use of a suitable inhibitor such as GGACK or specific anti-u-PA-antibody.

Sign in / Sign up

Export Citation Format

Share Document