Influence of ionic liquid composition on the stability of polyvinyl chloride-based ionic liquid inclusion membranes in aqueous solution

AIChE Journal ◽  
2016 ◽  
Vol 63 (2) ◽  
pp. 770-780 ◽  
Author(s):  
Francisca Tomás-Alonso ◽  
Aurora M. Rubio ◽  
Alfonso Giménez ◽  
Antonia P. de los Ríos ◽  
Maria J. Salar-García ◽  
...  
AIChE Journal ◽  
2011 ◽  
Vol 58 (2) ◽  
pp. 583-590 ◽  
Author(s):  
Francisco J. Hernández-Fernández ◽  
Antonia P. de los Ríos ◽  
Francisca Tomás-Alonso ◽  
José M. Palacios ◽  
Gloria Víllora

2020 ◽  
pp. 15-20
Author(s):  
Ersin Yucel ◽  
Mine Yucel

In this study, the usage of the peppermint (Mentha piperita) for extracting the metal ions [Mg (II), Cr (II), Ni (II), Cu (II), Zn (II), Cd (II), Pb (II)] that exist at water was investigated. In order to analyze the stability properties, Langmuir, Freundlich, Temkin and Dubinin-Radushkevich isotherms were used at removing the metal ions and the highest correlation coefficients (R2) were obtained at Langmuir isotherm. Therefore, it is seen that the Langmuir model is more proper than the Freundlich model. However, it was found that the correlation coefficients of removing Ni and Cd is higher at Freundlich model than Langmuir and low at Dubinin-Radushkevich isotherm. It is established that the biosorption amount increase depends on the increase of biosorbent and it can be achieved high efficiency (95%) even with small amount (0.6 mg, peppermint extract) at lead ions. It is also determined that the peppermint extracted that is used at this study shows high biosorption capacity for metal ions and can be used for immobilization of metals from polluted areas.


Materials ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2169
Author(s):  
Agnieszka Tabaczyńska ◽  
Anna Dąbrowska ◽  
Marcin Masłowski ◽  
Anna Strąkowska

Electro-conductive paths that are mechanically resistant and stable during simulated aging cycles are promising, in relation to the non-invasive application in e-textiles in our everyday surroundings. In the paper, an analysis of the influence of electro-conductive filler, as well as ionic liquid on surface resistance is provided. Authors proved that depending on the tested variant, obtained surface resistance may vary from 50 kΩ (when 50 phr of Ag and [bmim][PF6] ionic liquid applied) to 26 GΩ (when 25 phr of Ag and [bmim][PF6] ionic liquid applied). The samples were also evaluated after simulated aging cycles and the stability of electric properties was confirmed. Moreover, it was proved that the addition of ionic liquids reduced the resistance of vulcanizates, while no significant influence of the extrusion process on conductivity was observed.


RSC Advances ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 6577-6585
Author(s):  
Fenghui Wu ◽  
Chenyang Zhao ◽  
Guangfei Qu ◽  
Zhoupeng Yan ◽  
Yingda Zeng ◽  
...  

The environmental and health impacts caused by arsenic (As) in wastewater make it necessary to carefully manage As wastes.


1965 ◽  
Vol 18 (5) ◽  
pp. 651 ◽  
Author(s):  
RW Green ◽  
PW Alexander

The Schiff base, N-n-butylsalicylideneimine, extracts more than 99.8% beryllium into toluene from dilute aqueous solution. The distribution of beryllium has been studied in the pH range 5-13 and is discussed in terms of the several complex equilibria in aqueous solution. The stability constants of the complexes formed between beryllium and the Schiff base are log β1 11.1 and log β2 20.4, and the distribution coefficient of the bis complex is 550. Over most of the pH range, hydrolysis of the Be2+ ion competes with complex formation and provides a means of measuring the hydrolysis constants. They are for the reactions: Be(H2O)42+ ↔ 2H+ + Be(H2O)2(OH)2, log*β2 - 13.65; Be(H2O)42+ ↔ 3H+ + Be(H2O)(OH)3-, log*β3 -24.11.


Sign in / Sign up

Export Citation Format

Share Document