A combined complete pore blocking and cake filtration model for steady-state electric field-assisted ultrafiltration

AIChE Journal ◽  
2011 ◽  
Vol 58 (5) ◽  
pp. 1435-1446 ◽  
Author(s):  
Biswajit Sarkar ◽  
Sirshendu De
Keyword(s):  
Steady State ◽  
Electric Field ◽  
Cake Filtration ◽  
Pore Blocking ◽  
Filtration Model

scholarly journals Ultrafiltration membrane process for produced water treatment: experimental and modeling

2013 ◽  
Vol 3 (3) ◽  
pp. 249-259 ◽  
Author(s):  
Ramin Badrnezhad ◽  
Ali Heydari Beni
Keyword(s):  
Produced Water ◽  
Oxygen Demand ◽  
Experimental Results ◽  
Transmembrane Pressure ◽  
Permeation Flux ◽  
Cake Filtration ◽  
Pore Blocking ◽  
Uf Membranes ◽  
Almost All ◽  
Filtration Model

Produced water has been a big issue of water and environmental pollution. In this research, results of an experimental and modeling study on the separation of oil and salts from produced water using a rectangular flat sheet polyacrylonitrile (PAN) ultrafiltration (UF) membrane (nominal pore size of 10 nm) were analyzed. The effects of transmembrane pressure (TMP) (1, 2, 3 and 5 bar) on permeation flux of UF membranes for treatment of produced water were investigated. The results show that the average removal of chemical oxygen demand (COD) and total organic carbon (TOC) during the experiments were 94 and 83%, respectively. The UF membrane showed high potential for application in industry for produced water reusing purposes. The experimental results showed that oil retentions of almost all the membranes were over 99% and oil concentrations in the permeate were below 0.2 mg L–1. In addition, the fouling mechanism involved in UF processing of produced water was investigated by modeling. Experimental results of permeation flux were compared to the results of the fouling models. After the cake filtration model, the intermediate pore blocking model was found to predict the experimental data very well.

High-speed isotachophoresis. Analytical aspects of the steady-state longitudinal temperature profiles

1979 ◽  
Vol 44 (3) ◽  
pp. 841-853 ◽  
Author(s):  
Zbyněk Ryšlavý ◽  
Petr Boček ◽  
Miroslav Deml ◽  
Jaroslav Janák
Keyword(s):  
Steady State ◽  
Temperature Distribution ◽  
Electric Field ◽  
Field Intensity ◽  
Electric Field Intensity ◽  
Minor Component ◽  
Physical Models ◽  
Temperature Profiles ◽  
Longitudinal Temperature ◽  
Continuous Character

The problem of the longitudinal temperature distribution was solved and the bearing of the temperature profiles on the qualitative characteristics of the zones and on the interpretation of the record of the separation obtained from a universal detector was considered. Two approximative physical models were applied to the solution: in the first model, the temperature dependences of the mobilities are taken into account, the continuous character of the electric field intensity at the boundary being neglected; in the other model, the continuous character of the electric field intensity is allowed for. From a comparison of the two models it follows that in practice, the variations of the mobilities with the temperature are the principal factor affecting the shape of the temperature profiles, the assumption of a discontinuous jump of the electric field intensity at the boundary being a good approximation to the reality. It was deduced theoretically and verified experimentally that the longitudinal profiles can appreciably affect the longitudinal variation of the effective mobilities in the zone, with an infavourable influence upon the qualitative interpretation of the record. Pronounced effects can appear during the analyses of the minor components, where in the corresponding short zone a temperature distribution occurs due to the influence of the temperatures of the neighbouring zones such that the temperature in the zone of interest in fact does not attain a constant value in axial direction. The minor component does not possess the steady-state mobility throughout the zone, which makes the identification of the zone rather difficult.

Numerical study of electric field effects on the deformation of two-dimensional liquid drops in simple shear flow at arbitrary Reynolds number

2009 ◽  
Vol 626 ◽  
pp. 367-393 ◽  
Author(s):  
STEFAN MÄHLMANN ◽  
DEMETRIOS T. PAPAGEORGIOU
Keyword(s):  
Steady State ◽  
Shear Flow ◽  
Electric Field ◽  
Electric Fields ◽  
Simple Shear ◽  
Simple Shear Flow ◽  
Physical Parameters ◽  
Shear Stresses ◽  
Two Dimensional ◽  
Liquid Drops

The effect of an electric field on a periodic array of two-dimensional liquid drops suspended in simple shear flow is studied numerically. The shear is produced by moving the parallel walls of the channel containing the fluids at equal speeds but in opposite directions and an electric field is generated by imposing a constant voltage difference across the channel walls. The level set method is adapted to electrohydrodynamics problems that include a background flow in order to compute the effects of permittivity and conductivity differences between the two phases on the dynamics and drop configurations. The electric field introduces additional interfacial stresses at the drop interface and we perform extensive computations to assess the combined effects of electric fields, surface tension and inertia. Our computations for perfect dielectric systems indicate that the electric field increases the drop deformation to generate elongated drops at steady state, and at the same time alters the drop orientation by increasing alignment with the vertical, which is the direction of the underlying electric field. These phenomena are observed for a range of values of Reynolds and capillary numbers. Computations using the leaky dielectric model also indicate that for certain combinations of electric properties the drop can undergo enhanced alignment with the vertical or the horizontal, as compared to perfect dielectric systems. For cases of enhanced elongation and alignment with the vertical, the flow positions the droplets closer to the channel walls where they cause larger wall shear stresses. We also establish that a sufficiently strong electric field can be used to destabilize the flow in the sense that steady-state droplets that can exist in its absence for a set of physical parameters, become increasingly and indefinitely elongated until additional mechanisms can lead to rupture. It is suggested that electric fields can be used to enhance such phenomena.

scholarly journals Mapping of steady-state electric fields and convective drifts in geomagnetic fields – Part 1: Elementary models

2016 ◽  
Vol 34 (1) ◽  
pp. 55-65 ◽  
Author(s):  
A. D. M. Walker ◽  
G. J. Sofko
Keyword(s):  
Magnetic Field ◽  
Steady State ◽  
Electric Field ◽  
Electric Fields ◽  
Magnetic Field Line ◽  
Geomagnetic Field ◽  
Geomagnetic Field Models ◽  
Spatial Derivatives ◽  
Field Lines ◽  
The Magnetic Field

Abstract. When studying magnetospheric convection, it is often necessary to map the steady-state electric field, measured at some point on a magnetic field line, to a magnetically conjugate point in the other hemisphere, or the equatorial plane, or at the position of a satellite. Such mapping is relatively easy in a dipole field although the appropriate formulae are not easily accessible. They are derived and reviewed here with some examples. It is not possible to derive such formulae in more realistic geomagnetic field models. A new method is described in this paper for accurate mapping of electric fields along field lines, which can be used for any field model in which the magnetic field and its spatial derivatives can be computed. From the spatial derivatives of the magnetic field three first order differential equations are derived for the components of the normalized element of separation of two closely spaced field lines. These can be integrated along with the magnetic field tracing equations and Faraday's law used to obtain the electric field as a function of distance measured along the magnetic field line. The method is tested in a simple model consisting of a dipole field plus a magnetotail model. The method is shown to be accurate, convenient, and suitable for use with more realistic geomagnetic field models.

scholarly journals Calculating the Energy Spectrum of Complex Low-Dimensional Heterostructures in the Electric Field

2013 ◽  
Vol 2013 ◽  
pp. 1-7
Author(s):  
Svetlana N. Khonina ◽  
Sergey G. Volotovsky ◽  
Sergey I. Kharitonov ◽  
Nikolay L. Kazanskiy
Keyword(s):  
Steady State ◽  
Electric Field ◽  
Ground State ◽  
State Energy ◽  
Airy Functions ◽  
Piecewise Constant ◽  
Matrix Rank ◽  
The Matrix ◽  
Constant Potential ◽  
Low Dimensional

An algorithm for solving the steady-state Schrödinger equation for a complex piecewise-constant potential in the presence of theE-field is developed and implemented. The algorithm is based on the consecutive matching of solutions given by the Airy functions at the band boundaries with the matrix rank increasing by no more than two orders, which enables the characteristic solution to be obtained in the convenient form for search of the roots. The algorithm developed allows valid solutions to be obtained for the electric field magnitudes larger than the ground-state energy level, that is, when the perturbation method is not suitable.

Sign in / Sign up

Export Citation Format

Share Document