High-Efficiency, Matrix Interference-Free, General Applicable Probes for Bile Acids Extraction and Detection

Shuyao Huang; Jiating Zheng; Qian Yang; Guosheng Chen; Jianqiao Xu; Yong Shen; Yimin Zhang; Gangfeng Ouyang

doi:10.1002/advs.201800774

Uptake of taurocholic acid and cholic acid in isolated hepatocytes from rainbow trout

AJP Gastrointestinal and Liver Physiology ◽

10.1152/ajpgi.1994.267.3.g380 ◽

1994 ◽

Vol 267 (3) ◽

pp. G380-G386 ◽

Cited By ~ 2

Author(s):

C. M. Rabergh ◽

K. Ziegler ◽

B. Isomaa ◽

M. M. Lipsky ◽

J. E. Eriksson

Keyword(s):

Rainbow Trout ◽

Bile Acids ◽

Low Temperatures ◽

High Efficiency ◽

Isolated Hepatocytes ◽

Metabolic Inhibitors ◽

Dependent Manner ◽

Rainbow Trout Oncorhynchus Mykiss ◽

Transport Component ◽

Efficient Uptake

The uptake of the bile acids cholate (CHA) and taurocholate (TCHA) was studied in isolated hepatocytes from rainbow trout (Oncorhynchus mykiss). Both CHA and TCHA were taken up in a concentration- and temperature-dependent manner with optimum temperature at 15 degrees C and a strikingly efficient uptake even at low temperatures (0-5 degrees C). The total uptake was a combination of a saturable [Michaelis-Menten constant (Km) for CHA, 20 microM; Km for TCHA, 19 microM] and a nonsaturable component. The maximal uptake rate of the saturable component was 416 and 805 pmol.mg protein-1.min-1 for CHA and TCHA, respectively. The uptake of both bile acids was shown to be energy dependent, since it was inhibited by the metabolic inhibitors antimycin A, oligomycin and carbonyl cyanide m-chlorophenylhydrazone. The uptake was clearly Na+ independent, since isosmotic replacement of extracellular Na+ by Li+, choline, or K+ did not inhibit the uptake. Furthermore, it seemed to be independent of the presence of extracellular Cl-, since it was not inhibited by replacement of Cl- with sodium gluconate. On the whole, our results show that the hepatocellular uptake of bile acids in rainbow trout is mediated by a Na(+)-independent carrier system, with characteristics resembling the corresponding transport component in mammalian hepatocytes, but with high efficiency even at low temperatures.

Download Full-text

Microcalorimeters for X-Ray Spectroscopy

International Astronomical Union Colloquium ◽

10.1017/s0252921100107365 ◽

1988 ◽

Vol 102 ◽

pp. 41

Author(s):

E. Silver ◽

C. Hailey ◽

S. Labov ◽

N. Madden ◽

D. Landis ◽

...

Keyword(s):

High Resolution ◽

High Efficiency ◽

Thermal Response ◽

Low Noise ◽

High Resolution Spectroscopy ◽

Superconducting Transition ◽

Sapphire Substrates ◽

Laboratory Plasmas ◽

Adiabatic Demagnetization ◽

Theoretical Predictions

The merits of microcalorimetry below 1°K for high resolution spectroscopy has become widely recognized on theoretical grounds. By combining the high efficiency, broadband spectral sensitivity of traditional photoelectric detectors with the high resolution capabilities characteristic of dispersive spectrometers, the microcalorimeter could potentially revolutionize spectroscopic measurements of astrophysical and laboratory plasmas. In actuality, however, the performance of prototype instruments has fallen short of theoretical predictions and practical detectors are still unavailable for use as laboratory and space-based instruments. These issues are currently being addressed by the new collaborative initiative between LLNL, LBL, U.C.I., U.C.B., and U.C.D.. Microcalorimeters of various types are being developed and tested at temperatures of 1.4, 0.3, and 0.1°K. These include monolithic devices made from NTD Germanium and composite configurations using sapphire substrates with temperature sensors fabricated from NTD Germanium, evaporative films of Germanium-Gold alloy, or material with superconducting transition edges. A new approache to low noise pulse counting electronics has been developed that allows the ultimate speed of the device to be determined solely by the detector thermal response and geometry. Our laboratory studies of the thermal and resistive properties of these and other candidate materials should enable us to characterize the pulse shape and subsequently predict the ultimate performance. We are building a compact adiabatic demagnetization refrigerator for conveniently reaching 0.1°K in the laboratory and for use in future satellite-borne missions. A description of this instrument together with results from our most recent experiments will be presented.

Download Full-text

Imaging and diffraction modes in Scanning Transmission Electron Microscopy

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100144814 ◽

1986 ◽

Vol 44 ◽

pp. 684-687

Author(s):

J. M. Cowley ◽

R. Glaisher ◽

J. A. Lin ◽

H.-J. Ou

Keyword(s):

Scanning Transmission Electron Microscopy ◽

High Efficiency ◽

Fiber Optic ◽

Image Intensifier ◽

Detector System ◽

Detector Plane ◽

Secondary Electrons ◽

Transmission Electron ◽

Scanning Transmission ◽

Special Detector

Some of the most important applications of STEM depend on the variety of imaging and diffraction made possible by the versatility of the detector system and the serial nature, of the image acquisition. A special detector system, previously described, has been added to our STEM instrument to allow us to take full advantage of this versatility. In this, the diffraction pattern in the detector plane may be formed on either of two phosphor screens, one with P47 (very fast) phosphor and the other with P20 (high efficiency) phosphor. The light from the phosphor is conveyed through a fiber-optic rod to an image intensifier and TV system and may be photographed, recorded on videotape, or stored digitally on a frame store. The P47 screen has a hole through it to allow electrons to enter a Gatan EELS spectrometer. Recently a modified SEM detector has been added so that high resolution (10Å) imaging with secondary electrons may be used in conjunction with other modes.

Download Full-text

Influence of MBE Growth Conditions on Dislocation Densities of GaAs/Ge Epilayers Grown on Silicon Substrates

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100118692 ◽

1985 ◽

Vol 43 ◽

pp. 364-365

Author(s):

K.M. Hones ◽

P. Sheldon ◽

B.G. Yacobi ◽

A. Mason

Keyword(s):

High Efficiency ◽

Lattice Mismatch ◽

Low Cost ◽

Growth Conditions ◽

Nonradiative Recombination ◽

Device Structure ◽

Si Substrates ◽

Transmission Electron ◽

Dislocation Densities ◽

Dislocation Type

There is increasing interest in growing epitaxial GaAs on Si substrates. Such a device structure would allow low-cost substrates to be used for high-efficiency cascade- junction solar cells. However, high-defect densities may result from the large lattice mismatch (∼4%) between the GaAs epilayer and the silicon substrate. These defects can act as nonradiative recombination centers that can degrade the optical and electrical properties of the epitaxially grown GaAs. For this reason, it is important to optimize epilayer growth conditions in order to minimize resulting dislocation densities. The purpose of this paper is to provide an indication of the quality of the epitaxially grown GaAs layers by using transmission electron microscopy (TEM) to examine dislocation type and density as a function of various growth conditions. In this study an intermediate Ge layer was used to avoid nucleation difficulties observed for GaAs growth directly on Si substrates. GaAs/Ge epilayers were grown by molecular beam epitaxy (MBE) on Si substrates in a manner similar to that described previously.

Download Full-text

The use of high-resolution FESEM to study solid-state phase transformations and reactions

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100172875 ◽

1994 ◽

Vol 52 ◽

pp. 1028-1029

Author(s):

P. G. Kotula ◽

D. D. Erickson ◽

C. B. Carter

Keyword(s):

Solid State ◽

High Resolution ◽

Phase Transformations ◽

High Efficiency ◽

Sol Gel ◽

Quantitative Information ◽

Solid State Reactions ◽

Critical Dimensions ◽

Backscattered Electrons ◽

Backscattered Electron

High-resolution field-emission-gun scanning electron microscopy (FESEM) has recently emerged as an extremely powerful method for characterizing the micro- or nanostructure of materials. The development of high efficiency backscattered-electron detectors has increased the resolution attainable with backscattered-electrons to almost that attainable with secondary-electrons. This increased resolution allows backscattered-electron imaging to be utilized to study materials once possible only by TEM. In addition to providing quantitative information, such as critical dimensions, SEM is more statistically representative. That is, the amount of material that can be sampled with SEM for a given measurement is many orders of magnitude greater than that with TEM.In the present work, a Hitachi S-900 FESEM (operating at 5kV) equipped with a high-resolution backscattered electron detector, has been used to study the α-Fe2O3 enhanced or seeded solid-state phase transformations of sol-gel alumina and solid-state reactions in the NiO/α-Al2O3 system. In both cases, a thin-film cross-section approach has been developed to facilitate the investigation. Specifically, the FESEM allows transformed- or reaction-layer thicknesses along interfaces that are millimeters in length to be measured with a resolution of better than 10nm.

Download Full-text

Interlayer confinement synthesis of Ir nanodots/dual carbon as an electrocatalyst for overall water splitting

Journal of Materials Chemistry A ◽

10.1039/d0ta09358k ◽

2020 ◽

Author(s):

Yaru Li ◽

Yu-Quan Zhu ◽

Weili Xin ◽

Song Hong ◽

Xiaoying Zhao ◽

...

Keyword(s):

Water Splitting ◽

Noble Metal ◽

High Efficiency ◽

Overall Water Splitting ◽

Highly Dispersed

Rationally designing low-content and high-efficiency noble metal nanodots offers opportunities to enhance electrocatalytic performances for water splitting. However, the preparation of highly dispersed nanodots electrocatalysts remains a challenge. Herein, we...

Download Full-text