Microstructures and Properties of Aluminum-Copper Lap-Welded Joints by Cold Metal Transfer Technology

2015 ◽  
Vol 17 (10) ◽  
pp. 1480-1485 ◽  
Author(s):  
Jicai Feng ◽  
Yibo Liu ◽  
Qingjie Sun ◽  
Jinping Liu ◽  
Laijun Wu
Keyword(s):  
Welded Joints ◽  
Metal Transfer ◽  
Cold Metal Transfer ◽  
Cold Metal

Effect of path strategy on residual stress and distortion in laser and cold metal transfer hybrid additive manufacturing

2021 ◽  
pp. 102203
Author(s):  
Runsheng Li ◽  
Guilan Wang ◽  
Xushan Zhao ◽  
Fusheng Dai ◽  
Cheng Huang ◽  
...  
Keyword(s):  
Residual Stress ◽  
Additive Manufacturing ◽  
Metal Transfer ◽  
Cold Metal Transfer ◽  
Cold Metal

scholarly journals Influence of post weld heat treatment on tensile properties of cold metal transfer (CMT) arc welded AA6061-T6 aluminium alloy joints

2019 ◽  
Vol 28 (1) ◽  
pp. 135-145 ◽  
Author(s):  
Addanki Ramaswamy ◽  
Sudersanan Malarvizhi ◽  
Visvalingam Balasubramanian
Keyword(s):  
Heat Treatment ◽  
Tensile Properties ◽  
Gas Metal Arc Welding ◽  
Weight Ratio ◽  
Welding Process ◽  
Metal Transfer ◽  
Post Weld Heat Treatment ◽  
Cold Metal Transfer ◽  
Cold Metal ◽  
Weld Heat

AbstractAluminium alloys of 6xxx series are widely used in the fabrication of light weight structures especially, where high strength to weight ratio and excellent weld-ability characteristics are desirable. Gas metal arc welding (GMAW) is the most predominantly used welding process in many industries due to the ease of automation. In this investigation, an attempt has been made to identify the best variant of GMAW process to overcome the problems like alloy segregation, precipitate dissolution and heat affected zone (HAZ) softening. Thin sheets of AA6061-T6 alloy were welded by cold metal transfer (CMT) and Pulsed CMT (PCMT). Among the two joints, the joint made by PCMT technique exhibited superior tensile properties due to the mechanical stirring action in the weld pool caused by forward and rearward movement of the wire along with the controllable diffusion rate at the interface caused by shorter solidification time. However, softening still exists in the welded joints. Further to increase the joint efficiency and to minimize HAZ softening, the joints were subjected to post weld heat treatment (PWHT). Approximately 10% improvement in the tensile properties had been observed in the PWHT joints due to the nucleation of strengthening precipitates in the weld metal and HAZ.

Sign in / Sign up

Export Citation Format

Share Document