Power Magnetic Devices

2021 ◽  
Author(s):  
Scott D. Sudhoff
Keyword(s):  
Magnetic Devices

Corrosion of Electronic and Magnetic Devices and Materials

1996 ◽  
Vol 451 ◽  
Author(s):  
Gerald S. Frankel
Keyword(s):  
Thin Film ◽  
Failure Modes ◽  
Galvanic Corrosion ◽  
Potential Drop ◽  
Magnetic Devices ◽  
Disk Structure ◽  
Magnetic Layers ◽  
Ohmic Potential Drop ◽  
Corrosion Problem ◽  
Corrosion Susceptibility

ABSTRACTCorrosion of thin film structures commonly used in electronic and magnetic devices is discussed. Typical failure modes are presented, and galvanic corrosion is discussed in some detail since it is one common problem with such devices. A graphical explanation for the determination of the ohmic potential drop during galvanic corrosion is presented. The corrosion problem of thin film disks is shown to have changed during the past ten years owing to changes in disk structure. The corrosion susceptibility of two antiferromagnetic alloys used for exchange coupling to soft magnetic layers is discussed.

3-D optimal design of laminated yoke of billet heater for rolling wire rod using ON/OFF method

2012 ◽  
Vol 61 (1) ◽  
pp. 115-123 ◽  
Author(s):  
Norio Takahashi ◽  
Shunsuke Nakazaki ◽  
Daisuke Miyagi ◽  
Naoki Uchida ◽  
Keiji Kawanaka ◽  
...  
Keyword(s):  
Optimal Design ◽  
Local Heating ◽  
Optimization Method ◽  
Optimal Topology ◽  
Field Problem ◽  
Heating Efficiency ◽  
Magnetic Devices ◽  
Wire Rod ◽  
Magnetic Recording Heads ◽  
Sensitivity Method

3-D optimal design of laminated yoke of billet heater for rolling wire rod using ON/OFF method The optimization method using the ON/OFF sensitivity analysis has an advantage that an epoch-making construction of magnetic circuit may be obtained. Therefore, it is attractive for designers of magnetic devices. We have already developed the ON/OFF method for the optimization of a static magnetic field problem, and the effectiveness is verified by applying it to the optimization of magnetic recording heads. In this paper, the ON/OFF sensitivity method is extended to the optimization of the eddy current problem using the adjoint variable. The newly developed ON/OFF method is applied to the determination of the optimal topology of the yoke of the billet heater for rolling wire rod. As a result, the optimal shape of yoke, which we could not imagine beforehand can be obtained. It is shown that the local heating of the yoke was reduced without decreasing the heating efficiency.

Ordered Intermetallic Nanoparticles with High Catalytic Activity Prepared by an Electrochemically Induced Phase Transformation

2019 ◽  
Author(s):  
Du Sun ◽  
yunfei wang ◽  
Kenneth Livi ◽  
chuhong wang ◽  
ruichun luo ◽  
...  
Keyword(s):  
Catalytic Activity ◽  
Diffusion Mechanism ◽  
Reduction Reaction ◽  
Atomic Scale ◽  
High Catalytic Activity ◽  
Ambient Conditions ◽  
Magnetic Devices ◽  
Disordered Alloys ◽  
Ordered Intermetallic ◽  
Intermetallic Nanoparticles

<div> <p>The synthesis of alloys with long range atomic scale ordering (ordered intermetallics) is an emerging field of nanochemistry. Ordered intermetallic nanoparticles are useful for a wide variety of applications such as catalysis, superconductors, and magnetic devices. However, the preparation of nanostructured ordered intermetallics is challenging in comparison to disordered alloys, hindering progress in materials development. We report a process for converting colloidally synthesized ordered intermetallic PdBi<sub>2</sub> to ordered intermetallic Pd<sub>3</sub>Bi nanoparticles under ambient conditions by an electrochemically induced phase transition. The low melting point of PdBi<sub>2</sub> corresponds to low vacancy formation energies which enables the facile removal of the Bi from the surface, while simultaneously enabling interdiffusion of the constituent atoms via a vacancy diffusion mechanism under ambient conditions. The resulting phase-converted ordered intermetallic Pd<sub>3</sub>Bi exhibits 11x and 3.5x higher mass activty and high methanol tolerance for the oxygen reduction reaction compared to Pt/C and Pd/C, respectively,which is the highest reported for a Pd-based catalyst, to the best of our knowledge. These results establish a key development in the synthesis of noble metal rich ordered intermetallic phases with high catalytic activity, and sets forth guidelines for the design of ordered intermetallic compounds under ambient conditions.</p> </div>

Novel Magnetic Devices

2007 ◽  
Author(s):  
Ivan Schuller
Keyword(s):  
Magnetic Devices

scholarly journals Calculation of Electron Impact Single Ionization TDCS of Tungsten Atoms at 200, 500 and 1000 eV

Atoms ◽  
2021 ◽  
Vol 9 (2) ◽  
pp. 31
Author(s):  
Ghanshyam Purohit
Keyword(s):  
Electron Impact ◽  
Cross Sections ◽  
Projectile Energy ◽  
Cross Section Data ◽  
Scattered Electron ◽  
Fusion Plasma ◽  
Magnetic Devices ◽  
Single Ionization ◽  
Section Data ◽  
Sensitive Dependence

We report triple differential cross-sections (TDCSs) for the electron impact single ionization of tungsten atoms for the ionization taking place from the outer sub shells of tungsten atoms, viz. W (6s), W (5d), W (5p) and W (4f). The study of the electron-induced processes such as ionization, excitation, autoionization from tungsten and its charged states is strongly required to diagnose and model the fusion plasma in magnetic devices such as Tokamaks. Particularly, the cross-section data are important to understand the electron spectroscopy involved in the fusion plasma. In the present study, we report TDCS results for the ionization of W atoms at 200, 500 and 1000 eV projectile energy at different values of scattered electron angles. It was observed that the trends of TDCSs for W (5d) are significantly different from the trends of TDCSs for W (6s), W (5p) and W (4f). It was further observed that the TDCS for W atoms has sensitive dependence on value of momentum transfer and projectile energy.

scholarly journals An approach to emerging optical and optoelectronic applications based on NiO micro- and nanostructures

Nanophotonics ◽  
2021 ◽  
Vol 0 (0) ◽  
Author(s):  
María Taeño ◽  
David Maestre ◽  
Ana Cremades
Keyword(s):  
Gas Sensors ◽  
High Frequency ◽  
Future Research ◽  
Electrochromic Devices ◽  
Fuel Cell Electrodes ◽  
Magnetic Devices ◽  
Optical Microresonators ◽  
Optical Limiters ◽  
Recent Developments ◽  
Potential Applicability

Abstract Nickel oxide (NiO) is one of the very few p-type semiconducting oxides, the study of which is gaining increasing attention in recent years due to its potential applicability in many emerging fields of technological research. Actually, a growing number of scientific works focus on NiO-based electrochromic devices, high-frequency spintronics, fuel cell electrodes, supercapacitors, photocatalyst, chemical/gas sensors, or magnetic devices, among others. However, less has been done so far in the development of NiO-based optical devices, a field in which this versatile transition metal oxide still lags in performance despite its potential applicability. This review could contribute with novelty and new forefront insights on NiO micro and nanostructures with promising applicability in optical and optoelectronic devices. As some examples, NiO lighting devices, optical microresonators, waveguides, optical limiters, and neuromorphic applications are reviewed and analyzed in this work. These emerging functionalities, together with some other recent developments based on NiO micro and nanostructures, can open a new field of research based on this p-type material which still remains scarcely explored from an optical perspective, and would pave the way to future research and scientific advances.

Sign in / Sign up

Export Citation Format

Share Document