New paleomagnetic constraints on middle Miocene strike-slip faulting along the middle Altyn Tagh Fault

2017 ◽  
Vol 122 (6) ◽  
pp. 4106-4122 ◽  
Author(s):  
Bingshuai Li ◽  
Maodu Yan ◽  
Weilin Zhang ◽  
Xiaomin Fang ◽  
Qingquan Meng ◽  
...  
Geology ◽  
2000 ◽  
Vol 28 (3) ◽  
pp. 255 ◽  
Author(s):  
Eric Cowgill ◽  
An Yin ◽  
Wang Xiao Feng ◽  
Zhang Qing

2021 ◽  
Vol 13 (16) ◽  
pp. 3109
Author(s):  
Peng Chen ◽  
Bing Yan ◽  
Yuan Liu

Systematic deflection of drainage systems along strike-slip faults is the combination of repeated faulting slipping and continuous headward erosion accumulated on the stream channels. The measurement and analysis of systematically deflected stream channels will enhance our understanding on the deformational behaviors of strike-slip faults and the relationship between topographic response and active strike-slip faulting. In this study, detailed interpretation and analysis of remote sensing images and DEM data were carried out along the Altyn Tagh Fault, one typical large-scale strike-slip fault in the northern Tibetan Plateau, and together with the statistical results of offset amounts of 153 stream channels, revealed that (i) the drainage systems have been systematically deflected and/or offset in sinistral along the active Altyn Tagh Fault; (ii) The offset amounts recorded by stream channels vary in the range of 7 m to 72 km, and indicate a positively related linear relationship between the upstream length L and the offset amount D, the channel with bedrock upstream generally has a better correlation between L and D than that of non-bedrock upstream; (iii) River capture and abandonment are commonly developed along the Altyn Tagh Fault, which probably disturbed the continuous accumulation of offset recorded on individual stream channel, suggesting that the real maximum cumulative displacement recorded by stream channels might be larger than 72 km (lower bound) along the Altyn Tagh Fault. Along with the cumulative displacements recorded by other regional-scale strike-slip faults in the Tibetan Plateau, these results demonstrate that the magnitude of tectonic extrusion along these first-order strike-slip faults after the collision of India–Asia plates might be limited.


Geology ◽  
2000 ◽  
Vol 28 (3) ◽  
pp. 255-258 ◽  
Author(s):  
Eric Cowgill ◽  
An Yin ◽  
Wang Xiao Feng ◽  
Zhang Qing

2018 ◽  
Vol 123 (9) ◽  
pp. 7207-7224 ◽  
Author(s):  
Bingshuai Li ◽  
Maodu Yan ◽  
Weilin Zhang ◽  
Xiaomin Fang ◽  
Yongpeng Yang ◽  
...  

2017 ◽  
Vol 54 (3) ◽  
pp. 278-289 ◽  
Author(s):  
Zhiguo Zhang ◽  
Junsheng Nie ◽  
Xiaomin Fang

The Altyn Tagh Fault (ATF) defines the northern margin of the Tibetan Plateau; therefore, its tectonic history is key to understanding the plateau’s northward growth. However, our understanding of ATF tectonics is incomplete, owing in part to a lack of constraints in detailed basin evolution studies of this region. Approximately 1700 m of Middle Miocene – Pliocene clastic strata extracted from a section of the Yitunbulake Basin adjacent to the midsection of the ATF records the uplift of the Altyn Tagh Range. This paper reports 490 concordant detrital zircon U–Pb ages derived from this set of strata. In addition, paleocurrents and conglomerate clastic compositions were measured to determine the provenance of the basin. The dominant detrital zircon age populations within these sedimentary rocks are 260–240, 500–400, and 950–900 Ma. The 260–240 Ma component decreases sharply above the Lower (Xia) Youshashan (XYSS) Formation. Moreover, we performed (U–Th)/He dating on 260–240 Ma detrital zircons from the XYSS Formation to determine its source region. The results indicate that sandstones in this formation are most likely sourced immediately from plutonic rocks widely distributed in the Eastern Kunlun Mountains. The upward change in detrital zircon U–Pb age components in the section demonstrates that widespread surface uplift of the Akatengneng Mountains in the midsection of the ATF likely occurred after ∼16–15 Ma, which is synchronous with accelerated tectonic deformation along the ATF and a rapid increase in the sedimentation rate in the Qaidam Basin since the Middle Miocene.


2017 ◽  
Vol 9 (1) ◽  
Author(s):  
Jianming Guo ◽  
Xuebing Wei ◽  
Guohui Long ◽  
Bo Wang ◽  
Hailong Fan ◽  
...  

AbstractThe Qaidam basin, bounded by the Altyn Tagh fault in the north, is located in the northeast of the Tibet plateau, and it has important implications for understanding the history and mechanism of Tibetan plateau formation during the Cenozoic Indo-Eurasia collision. In this study, we constructed the main geological structures and surfaces in three dimensions through the interpolation of regularly spaced 2D seismic sections, constrained by wells data and surface geology of the Qaidam basin in northeast Tibet. Meanwhile the Cenozoic tectonic history of the Qaidam basin was reconstructed and the uplift mechanism of the Tibetan plateau was discussed. This study presents the subsurface data in conjunction with observations and analysis of the stratigraphic and sedimentary evolution. The Cenozoic deformation history of the Qaidam basin shows geologic synchroneity with uplifting history of the Tibet Plateau. It is therefore proposed that the deformation and uplifting in the south and north edges of the Tibet Plateau was almost synchronous. The total shortening and shortening rate during Cenozoic reached 25.5 km and 11.2% respectively across the Qaidam basin, indicating that the loss of the left-lateral strike slip rates of the Altyn Tagh fault has been structurally transformed into local crustal thickening across NW-trending folds and thrust faults. Meanwhile there is an about 11° vertical component along the strike-slip Altyn Tagh fault, the block oblique slip shows one more growth mechanism of the northeast Tibet.


Sign in / Sign up

Export Citation Format

Share Document