Laboratory experiments on diffusive convection layer thickness and its oceanographic implications

Shuang-Xi Guo; Sheng-Qi Zhou; Ling Qu; Yuan-Zheng Lu

doi:10.1002/2016jc012172

Melting heat transfer in the stagnation-point flow of Maxwell fluid with double-diffusive convection

International Journal of Numerical Methods for Heat &amp Fluid Flow ◽

10.1108/hff-09-2012-0219 ◽

2014 ◽

Vol 24 (3) ◽

pp. 760-774 ◽

Cited By ~ 39

Author(s):

Tasawar Hayat ◽

Muhammad Farooq ◽

Ahmad Alsaedi

Keyword(s):

Heat Transfer ◽

Boundary Layer ◽

Velocity Profile ◽

Layer Thickness ◽

Stagnation Point ◽

Boundary Layer Thickness ◽

Double Diffusive Convection ◽

Content Type ◽

Diffusive Convection ◽

Double Diffusive

Purpose – The purpose of this paper is to analyze the melting heat transfer in the stagnation-point flow with double-diffusive convection. Design/methodology/approach – Series solutions for velocity, temperature and concentration are constructed via homotopy analysis method. Findings – The authors observed that the behaviors of N, ?2 and M on the velocity and boundary layer thickness are qualitatively similar. Further, for A<1 the velocity profile and boundary layer thickness increase with the increase of A. However, when A>1 then the velocity profile increases but the boundary layer thickness decreases when A is increased. Originality/value – This analysis has not been discussed in the literature previously.

Download Full-text

New layer thickness parameterization of diffusive convection in the ocean

Dynamics of Atmospheres and Oceans ◽

10.1016/j.dynatmoce.2016.01.001 ◽

2016 ◽

Vol 73 ◽

pp. 87-97 ◽

Cited By ~ 2

Author(s):

Sheng-Qi Zhou ◽

Yuan-Zheng Lu ◽

Xue-Long Song ◽

Ilker Fer

Keyword(s):

Layer Thickness ◽

Diffusive Convection

Download Full-text

Covering of cometary nucleus by refractory crust and its evolution into asteroid-like body

International Astronomical Union Colloquium ◽

10.1017/s0252921100031675 ◽

1999 ◽

Vol 173 ◽

pp. 365-370

Author(s):

Kh.I. Ibadinov

Keyword(s):

Laboratory Experiments ◽

Cometary Nucleus ◽

Sublimation Rate ◽

Cometary Nuclei ◽

Short Period Comet ◽

Short Period ◽

Brightness Decrease ◽

Crust Thickness ◽

Ice Sublimation ◽

Period Comet

AbstractFrom the established dependence of the brightness decrease of a short-period comet dependence on the perihelion distance of its orbit it follows that part of the surface of these cometary nuclei gradually covers by a refractory crust. The results of cometary nucleus simulation show that at constant insolation energy the crust thickness is proportional to the square root of the insolation time and the ice sublimation rate is inversely proportional to the crust thickness. From laboratory experiments resulted the thermal regime, the gas productivity of the nucleus, covering of the nucleus by the crust, and the tempo of evolution of a short-period comet into the asteroid-like body studied.

Download Full-text

Structure and Orientation of As Precipitates in LT-MBE Grown GaAs

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100088816 ◽

1991 ◽

Vol 49 ◽

pp. 900-901 ◽

Cited By ~ 1

Author(s):

Alain Claverie ◽

Zuzanna Liliental-Weber

Keyword(s):

Transport Properties ◽

Layer Thickness ◽

Growth Temperature ◽

Low Temperatures ◽

Lattice Parameter ◽

Crystalline Quality ◽

Insulating Properties ◽

Lt Gaas

GaAs layers grown by MBE at low temperatures (in the 200°C range, LT-GaAs) have been reported to have very interesting electronic and transport properties. Previous studies have shown that, before annealing, the crystalline quality of the layers is related to the growth temperature. Lowering the temperature or increasing the layer thickness generally results in some columnar polycrystalline growth. For the best “temperature-thickness” combinations, the layers may be very As rich (up to 1.25%) resulting in an up to 0.15% increase of the lattice parameter, consistent with the excess As. Only after annealing are the technologically important semi-insulating properties of these layers observed. When annealed in As atmosphere at about 600°C a decrease of the lattice parameter to the substrate value is observed. TEM studies show formation of precipitates which are supposed to be As related since the average As concentration remains almost unchanged upon annealing.

Download Full-text

The stabilization of B.C.C. Cu in Cu/Nb nanolayered composites

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100163605 ◽

1996 ◽

Vol 54 ◽

pp. 228-229

Author(s):

H. Kung ◽

A.J. Griffin ◽

Y.C. Lu ◽

K.E. Sickafus ◽

T.E. Mitchell ◽

...

Keyword(s):

Electrical Resistivity ◽

Layer Thickness ◽

Volume Fraction ◽

Ion Beam ◽

High Strength ◽

Cross Sectional ◽

Metastable Structure ◽

High Resolution Tem ◽

Potential Improvement ◽

Two Phases

Materials with compositionally modulated structures have gained much attention recently due to potential improvement in electrical, magnetic and mechanical properties. Specifically, Cu-Nb laminate systems have been extensively studied mainly due to the combination of high strength, and superior thermal and electrical conductivity that can be obtained and optimized for the different applications. The effect of layer thickness on the hardness, residual stress and electrical resistivity has been investigated. In general, increases in hardness and electrical resistivity have been observed with decreasing layer thickness. In addition, reduction in structural scale has caused the formation of a metastable structure which exhibits uniquely different properties. In this study, we report the formation of b.c.c. Cu in highly textured Cu/Nb nanolayers. A series of Cu/Nb nanolayered films, with alternating Cu and Nb layers, were prepared by dc magnetron sputtering onto Si {100} wafers. The nominal total thickness of each layered film was 1 μm. The layer thickness was varied between 1 nm and 500 nm with the volume fraction of the two phases kept constant at 50%. The deposition rates and film densities were determined through a combination of profilometry and ion beam analysis techniques. Cross-sectional transmission electron microscopy (XTEM) was used to examine the structure, phase and grain size distribution of the as-sputtered films. A JEOL 3000F high resolution TEM was used to characterize the microstructure.

Download Full-text

When Does Voice Have to be More Than Only Listening? Procedural Justice Effects as a Function of Confident Leadership

Journal of Personnel Psychology ◽

10.1027/1866-5888/a000011 ◽

2010 ◽

Vol 9 (2) ◽

pp. 69-78 ◽

Cited By ~ 8

Author(s):

David De Cremer ◽

Maarten Wubben

Keyword(s):

Procedural Justice ◽

Interaction Effect ◽

Laboratory Experiments ◽

Negative Emotions

The present research examined how voice procedures and leader confidence affect participants’ negative emotions and willingness to withdraw. It was predicted that receiving voice would be valued out of instrumental concerns, but only when the enacting leader was high in confidence. Two laboratory experiments indeed showed an interaction between type of voice (pre-decisional vs. post-decisional) and leader’s confidence (low vs. high) on participants’ negative emotions and willingness to withdraw. In particular, post-decision voice only led to more negative responses than did pre-decision voice when the enacting leader was high in confidence. Negative emotions mediated this interaction effect of type of voice on willingness to withdraw. Implications for integrating the leadership and procedural justice literatures are discussed.

Download Full-text