Kinetic Mechanisms and Rate Expressions for Heterogeneous Surface-Catalyzed Chemical Reactions

2020 ◽  
Vol 15 (2) ◽  
pp. 7-28
Author(s):  
Igor Povar

The main scientific achievements of great significance accomplished by Professor Ilie Fishtik at the University of Iowa and the Worcester Polytechnic Institute, in several fields of the physical chemistry as chemical thermodynamics, kinetics and heterogeneous catalysis were revealed and briefly analysed. Fundamental equations of chemical thermodynamics within the De Donder (stoichiometric) approach were reformulated in terms of a special class of chemical reactions, called as response reactions. Using this approach, the unusual behaviour of chemical equilibrium systems, to interpret the apparent contradictions to Le Chatelier principle and to discover hitherto unnoticed thermodynamic identities, was rationalised. The stabilities of chemical species were formulated in terms of a certain class of stoichiometrically unique chemical reactions and their thermochemical characteristics. A completely new approach for the generation and simplification of kinetic mechanisms for complex reaction systems was developed and applied. Based on a new type of reaction networks, referred to as reaction route graphs, a systematic method of analysis and reduction of a microkinetic mechanism was established and employed.


Author(s):  
H.H. Rotermund

Chemical reactions at a surface will in most cases show a measurable influence on the work function of the clean surface. This change of the work function δφ can be used to image the local distributions of the investigated reaction,.if one of the reacting partners is adsorbed at the surface in form of islands of sufficient size (Δ>0.2μm). These can than be visualized via a photoemission electron microscope (PEEM). Changes of φ as low as 2 meV give already a change in the total intensity of a PEEM picture. To achieve reasonable contrast for an image several 10 meV of δφ are needed. Dynamic processes as surface diffusion of CO or O on single crystal surfaces as well as reaction / diffusion fronts have been observed in real time and space.


Author(s):  
Anthony S-Y Leong ◽  
David W Gove

Microwaves (MW) are electromagnetic waves which are commonly generated at a frequency of 2.45 GHz. When dipolar molecules such as water, the polar side chains of proteins and other molecules with an uneven distribution of electrical charge are exposed to such non-ionizing radiation, they oscillate through 180° at a rate of 2,450 million cycles/s. This rapid kinetic movement results in accelerated chemical reactions and produces instantaneous heat. MWs have recently been applied to a wide range of procedures for light microscopy. MWs generated by domestic ovens have been used as a primary method of tissue fixation, it has been applied to the various stages of tissue processing as well as to a wide variety of staining procedures. This use of MWs has not only resulted in drastic reductions in the time required for tissue fixation, processing and staining, but have also produced better cytologic images in cryostat sections, and more importantly, have resulted in better preservation of cellular antigens.


Author(s):  
David R. Veblen

Extended defects and interfaces control many processes in rock-forming minerals, from chemical reactions to rock deformation. In many cases, it is not the average structure of a defect or interface that is most important, but rather the structure of defect terminations or offsets in an interface. One of the major thrusts of high-resolution electron microscopy in the earth sciences has been to identify the role of defect fine structures in reactions and to determine the structures of such features. This paper will review studies using HREM and image simulations to determine the structures of defects in silicate and oxide minerals and present several examples of the role of defects in mineral chemical reactions. In some cases, the geological occurrence can be used to constrain the diffusional properties of defects.The simplest reactions in minerals involve exsolution (precipitation) of one mineral from another with a similar crystal structure, and pyroxenes (single-chain silicates) provide a good example. Although conventional TEM studies have led to a basic understanding of this sort of phase separation in pyroxenes via spinodal decomposition or nucleation and growth, HREM has provided a much more detailed appreciation of the processes involved.


1883 ◽  
Vol 15 (366supp) ◽  
pp. 5844-5844
Author(s):  
MM. Jules Lefort ◽  
P. Thibault

Sign in / Sign up

Export Citation Format

Share Document